Creality BLTouch Manual Book

AUTO BED LEVELING SENSOR FOR 3D PRINTER
This guidebook is for Creality V1 mainboard.It include but not
limited to the following 3d printer:
CR-10/Ender-3
File download: https://www.creality3d.cn/download/
①

Packing List

BLTouch Connectors
ISP Pinboard
③
Update Firmware
Mianboard
1、Connect ISP Pinboard and Burner.
2、Open the control box and find out the mainboard
3、Insert ISP pinboard into the mainboard 2X3 pins as
the sign shows.
4、Insert the burner into computer USB port.
BLTouch Guidebook
for Creality V1 Mainboard
Rack Pinboard A
Tie
M3X8 2PCS M3X6 2PCS
Burner
MISO VCC
SCK MOSI
RST GND
ISP Pinboard
Burner
PC
Website
Scan QR code to view detailed instruction
SHENZHEN CREALITY 3D TECHNOLOGY CO., LTD.
12/F, Block 3, JinChengYuan, Huafan Road, Tongsheng Community,
Dalang, Longhua District, Shenzhen, China, 518109
Official Website: www.creality3d.cn
Tel: 0755-2105 9455
E-mail: info@creality3d.cn cs@creality3d.cn
②
Circuit Principle
Creality V1
Mainboard
2Pin
4
1
2
3
5
1、Open progisp.exe
2、Select Chip ATmega1284p.
3、Click ... → Set Low Value=DC, HighValue=D6, ExtValue=FD→Click Write
and close the window.
4、load Flash→Select .hex file.
5、Click Auto to update firmware，wait until it finishs, then close.
6、Unplug the ISP Pinboard from mainboard.
Facebook
MISO VCC
SCK MOSI
RST GND
ISP Pinboard Burner
Z Stop
Screen
3Pin
Pinboard A
Connectors
BLTouch
VCC
GND
SIG
ATmega1284P
PC
5Pin