Mr. Christmas Deluxe Panoramic Motion Projector Instruction Manual

THIS PRODUCT IS NOT A TOY! Please read this entire instruction booklet before using.
1.

DESCRIPTION

Thank you for purchasing the Deluxe Panoramic Motion Projector. It projects multi-colored changeable animated holiday images on any flat surface. The package includes the unit,
ground stake, 10 slides, an adapter and extra bulb. This product is not a toy and is not intended for use by children.
Electrical Rating: 120V AC 60Hz 70VA
Normal operating temperature is from -20°C / -4°F to 35°C / 95°F
At extremely cold temperatures (-20°C / -4°F) the spinning image may not start for a few minutes.
2.

UNPACKING THE UNIT

Your Deluxe Panoramic Motion Projector has been carefully packed to ensure that it will reach you in perfect condition. To unpack follow these steps:
A. Carefully open the box and pull out the styrofoam insert and remove the unit from the styrofoam insert.
B. Remove the film pouch and the ground stake from the styrofoam insert.
C. Remove the plastic bag from the unit. The unit is now free of the packaging. Be sure to save the packaging of your unit from season to season.
D. A spare bulb packed in a white box is included in the packaging to be used only when the bulb in the unit fails.
3.

OPERATION

A. Insert the AC adapter plug into the power jack and plug the adapter into a nearby working outlet. The adapter is intended to be correctly oriented in a vertical or floor mount
position.
B. Press the end of the unit line cord into the adaptor's round opening.
C. The two prongs inside the end of the unit line cord should line up with the two holes inside the adaptor's round opening.
Turn the ON / OFF switch to the "ON" position, the moving image will appear.
D.
E. Position the projected image by tilting and turning the projector housing.
F. Move the lens in or out to focus.
G. To make the image bigger, move the projector back from the intended surface.
H. There is a speed control knob at the bottom of the unit. Turn the speed control knob to slow or fast depending on desired speed.
4.

MOUNTING THE UNIT

A. Determine the Deluxe Panoramic Motion Projector position for desired location and image size.
B. Before inserting the ground stake, check the ground for any electrical, gas, plumbing, or phone line hazards. Do not position the lens of the Deluxe Panoramic Motion Projector
in direct path of the sun as this may cause a magnifying lens effect and burn the image film.
C. Insert the ground stake into the ground. If the ground is hard, a hammer may be needed. In this case, use something such as a wooden block to prevent damage to the top of the
ground stake.
D. Loosen the screw found on the mounting stem underneath the projector to its extreme open position.
E. Insert the ground stake making sure the notch at the top of the ground stake is lined up with the guider inside the mounting stem and push in.
F. Tighten the screw on the mounting screw.
5. TO CHANGE FILM
A. Flip up the front housing as shown.
B. Pull out film from the projector and replace with a new film by covering the film retaining ring.
IMPORTANT: Always place the film with the silver surface facing down to avoid damaging the film.
5841 East Shelby Drive
Memphis, TN 38141
Phone: 1-800-467-9627
Deluxe Panoramic Motion Projector
INSTRUCTION MANUAL
Item No. 60515(D)
1
http://www.mrchristmas.com
 Mr. Christmas, Inc.
Made in China
20150803 (v.0)