Instruction 22: Assigning New Remote Control - Nice 7251 Installation And Programming Manual

22
ASSIGNING NEW REMOTE CONTROL
Procure a functioning Nice 2-button or 4-button remote control with a battery installed (IMAGE 23-1) and
assign it to the Nice
OXI/A
1. Press and hold the program button on the side of the Nice
until the green LED lights up on the side of the receiver, then release the button.
2. Within 10 seconds, press and hold any key on the Nice remote control until the LED in the Nice receiver
blinks green 3 times, indicating that the remote control is programmed to control the receiver.
3. After the LED on the Nice receiver blinks green 3 times, another 10 second interval is started to program
another Nice remote control if desired.
4. Repeat step 3 to program the additional Nice remote control (transmitter). Step 3 may be repeated as
many times as necessary to program all available Nice remote controls.
5. Verify that the Nice remote control(s) can control the gate by pressing one or more buttons individually
on the remote control(s).
6. If remotes do not function properly, refer to the FUNCTION/Radio Ch. Menu in SECTION 8 to assign the
correct function to the radio channels.
GREEN
LED
2-BUTTON REMOTE (MIDDLE) & 4-BUTTON REMOTE (RIGHT)
www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com
7251 / 7351 Slide Gate Operator
INSTALLATION AND PROGRAMMING MANUAL
receiver as follows:
PROGRAM
BUTTON
IMAGE 23-1: OXI/A RECEIVER (LEFT),
receiver module (IMAGE 23-1, Left)
OXI/A
41