Dell 3000CN Remanufacturing Instructions page 4

DELL 3000CN TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
9. Make sure the replacement chip tabs enter the slots during 10. Replacement chip installed.
insertion so that they lock in place.
TROUBLESHOOTING DEFECTS DUE TO CARTRIDGE REMANUFACTURING
Problem:
Printer is not reading/not recognizing the cartridge.
Details:
The machine reads the amount of waste carrier-toner located on the waste hopper bin. If the waste hopper bin compartment is
full, the machine might read that the toner cartridge is empty and thus, showing a "toner low" message. After refilling, follow these
simple steps to continue printing:
Suggestion:
1. Turn OFF the printer for 3 to 5 minutes, and turn it back ON again.
2. Once the printer is ON, remove the cartridge from the printer, shake and install it again.
3. If steps 1 and 2 did not work, remove the cartridge and empty any carrier-toner left on the waste hopper bin.
www.uninetimaging.com
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com