Canon LM-V1 User Manual page 49

Attaching the Grip Unit
1.
Turn off the camera.
2.
Pass the rods of the optional SU-15 Shoulder
Support Unit through the grip connecting arm
( ), adjust the arm's position (front/back), and
turn the grip connecting arm screw clockwise to
secure the arm ( ).
• After securing the arm, attach the rod stoppers
supplied with the SU-15 ( , 0 47).
3.
Attach the grip unit to the grip connecting arm
( ).
• Partially tighten the M6 bolt using the hex wrench
for a provisional fix. Adjust the angle of the grip unit to the desired position and then fasten the bolt
firmly.
4.
Using the hex wrench for 0.64 cm, 1/4" screws, loosen the bolt at the bottom of the grip
connecting arm ( ). Adjust the grip unit's position (left/right) as necessary and then fasten the
bolt to secure the grip unit in place.
5.
Connect the grip unit's 12-pin interface cable to the LENS terminal on the camera or optional
EU-V2 Expansion Unit 2 ( ).
Align the O mark on the plug with the ↓ mark on the terminal.
•
• You can adjust the cable's length.

Adjusting the 12-pin Interface Cable's Length
1.
Remove the grip belt and use a coin or similar
item to open the cable compartment cover
( ).
2.
Adjust the cable's length ( ).
3.
Close the cable compartment cover ( ).
Controlling the Aperture using the Grip
1.
Set the IRIS switch to M (manual) ( ).
• You can set the switch to A instead to control
the aperture from the camera or another
accessory connected to it.
2.
Turn the grip control dial to set the aperture
value ( ).
3.
Even when the IRIS switch is set to M, you
can control the aperture from the camera or
another accessory connected to it as long as
you hold the IRIS button pressed down ( ).
50
SHOOTING STYLES AND CONFIGURATION EN