Tires; Tire Pressure - Kubota BX2370 Workshop Manual
Tractor,mower, front loader
Hide thumbs
Also See for BX2370:
- User manual ,
- Operator's manual (93 pages) ,
- Workshop manual (31 pages)
Table of Contents
Advertisement
BX1870,BX2370,BX2670,LA203A,LA243A,RCK48(P),RCK54(P),RCK60B,RCK60D,RCK54D, WSM
9. TIRES
[1] TIRE PRESSURE
WARNING
• Do not attempt to mount a tire on a rim. This should be done by a qualified person with the proper
equipment.
• Always maintain the correct tire pressure.
Do not inflate tires above the recommended pressure shown in the operator's manual.
IMPORTANT
• Do not use tires larger than specified.
• When you intend to mount different size of tires from equipped ones, consult your distributor about front
drive gear ratio for detail.
Excessive wear of tires may occur due to improper gear ratio.
[BX1870D]
24 × 12.00 – 12 Turf
Rear
24 × 12.00 – 12 Bar
16 × 7.50 – 8 Turf
Front
16 × 7.50 – 8 Bar
[BX2370D and BX2670D]
26 × 12.00 – 12 Turf
Rear
26 × 12.00 – 12 Bar
26 × 12.00 – 12 Ind.
18 × 8.50 – 10 Turf
Front
18 × 8.50 – 10 Bar
18 × 8.50 – 10 Ind.
Though the tire pressure is factory-set to the prescribed level, it naturally drops slowly in the course of time.
Thus, check it everyday and inflate as necessary.
NOTE
• Maintain the maximum pressure in front tires, if using a front loader or when equipped with a full load of
front weights.
Tire sizes
100 kPa (1.0 kgf/cm
120 kPa (1.2 kgf/cm
120 kPa (1.2 kgf/cm
150 kPa (1.5 kgf/cm
Tire sizes
100 kPa (1.0 kgf/cm
120 kPa (1.2 kgf/cm
120 kPa (1.2 kgf/cm
120 kPa (1.2 kgf/cm
150 kPa (1.5 kgf/cm
150 kPa (1.5 kgf/cm
G-64
Inflation pressure
2
, 14 psi)
2
, 17 psi)
2
, 17 psi)
2
, 22 psi)
Inflation pressure
2
, 14 psi)
2
, 17 psi)
2
, 17 psi)
2
, 17 psi)
2
, 22 psi)
2
, 22 psi)
GENERAL
9Y1210855GEG0082US0
KiSC issued 02, 2017 A
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the BX2370 and is the answer not in the manual?
Questions and answers
Remove the drop down mower attatchment, now can't get the tractor in gear to drive?
To get a Kubota BX2370 tractor in gear after removing the drop-down mower attachment, follow these steps:
1. Ensure Frame Link is Up: Lift the frame link to the "TOP" position, as it should be raised when the mower is not attached.
2. Check Rear Lock: Make sure the rear lock is unlocked.
3. Verify Universal Joint Position: Ensure the universal joint is in the rear position.
4. Set PTO Clutch Lever: The PTO clutch lever should be in the "OFF" position.
5. Engage 4WD (if needed): Start the engine and engage four-wheel drive if necessary.
6. Set Gear Range: Shift the range gear lever to "LOW" before moving.
7. Release Parking Brake: Disengage the parking brake before driving.
Once these steps are completed, the tractor should be ready to move and shift into gear properly.
This answer is automatically generated