Table of Contents
Advertisement
MG25CL Built-in Microwave & Grill
Troubleshooting
The following circumstances may not be a problem. Do not contact the customer
services until the problem has been confirmed.
Fault
Microwave oven
interference
Steam accumulating or
hot air released out of
vents
Oven started accidentally
with no food inside
Oven cannot be started
MG25CL-C&L-A5-GB-IM-06.indd 21
Cause
Radio and TV reception
interference may be
noticed when the
microwave oven
operating. This is similar
to the interference
of small electrical
appliances such as a
mixer, vacuum cleaner or
electric fan.
Low-power microwave
cooking.
The steam given off
from food will mostly be
released through the
vents, although some
could accumulate on
places such as the oven
door.
Human error.
Appliance error.
Power cord not plugged
in properly.
Fuse blowing or circuit
breaker tripping.
Trouble with socket.
Troubleshooting
Solution
This does not indicate
malfunctioning.
This does not indicate
malfunctioning.
This does not indicate
malfunctioning.
Please dry surfaces with
condensation.
Stop the appliance, this
is very dangerous. It
is forbidden to run the
appliance with no food
inside.
Contact the customer
services.
Disconnect the plug and
connect again after 10
seconds.
Switch off and replace
the fuse.
Test socket with another
electrical appliance.
GB
IE
21
9/30/13 9:25 AM
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MG25CL and is the answer not in the manual?
Questions and answers
The digital display isn't working
The provided context does not contain specific instructions for fixing a digital display issue on a Cooke & Lewis MG25CL. However, you can try the following general troubleshooting steps:
1. Check Power Supply – Ensure the microwave is plugged in properly and the power outlet is functioning.
2. Reset the Appliance – Unplug the microwave for a few minutes and then plug it back in to reset the system.
3. Inspect for Damage – Check the power cord and plug for any visible damage.
4. Confirm Settings – If the display turns off after a minute of inactivity, press "START/+30Sec./Confirm" to check if it responds.
5. Contact Customer Services – If the issue persists, contact the authorized service center for assistance.
If the display is still not working, professional repair may be required.
This answer is automatically generated