Using Cctalk Commands/Machine Service Menu - NRI V2 eagle Operating Instructions Manual

To save with the normal acceptance band:
6a
Set DIL switch S6 back to OFF (down).
Successful saving is signalled by the acceptance gate attracting
once. A saving error is signalled by the acceptance gate attracting
twice (brief cracking sounds), if e.g. the acceptance band of
the coins inserted and the acceptance band of a coin channel
already programmed overlap, or the measured values generated are too different and the
tolerances would become too large.
To save with the wide acceptance band:
6b
Set an additional DIL switch S3–5 (here: S3) to ON (up).
The acceptance band has been widened.
Now you can set DIL switch S6 to OFF (down) again.
Successful saving is signalled by the acceptance gate attracting
once. A saving error is signalled by the acceptance gate attracting
twice (brief cracking sounds), if e.g. the acceptance band of
the coins inserted and the acceptance band of a coin channel
already programmed overlap, or the measured values generated
are too different and the tolerances would become too large.
7
Set DIL switch S3–5 to OFF again (down)
8
Remount the coin validator in the machine.
9
Switch power off and on again.
10
Enable the taught coin channel (here: 15) via the control system
and adapt sorting, if necessary.
The coin validator will now accept the new coin type/token for payment.
7.3.2

... using ccTalk commands/machine service menu

If the coin validator has been programmed accordingly in the factory and is not write-protected,
coin channels can be taught using ccTalk command set (cp. separate v
specification, available on request) in order to create new acceptance bands. This command
set can be used to start and monitor the teach mode e.g. via a service menu.
The new acceptance bands are generated and saved by inserting ten coins/tokens of the new
type. After saving of the acceptance bands the coin validator will accept the new coin type/
token for payment.
Fur further information about teaching of coins/tokens via the service menu please refer to the
instruction manual for the machine.
BA_v2_eagle_serial_EN_2-1
To cancel the process first set the DIL switch of the respective coin channel
(S3–5, here: S4) and then DIL switch S6 to OFF (down).
To cancel the process first set the DIL switch of the respective coin channel
(S3–-5, here: S4) and the additional DIL switch for the wide acceptance band
(here: S3) and then DIL switch S6 to off (down).
Should you overwrite a configured coin channel in the teach mode, all
properties assigned to this channel (e. g. coin ID, sorting etc.) must be
adapted to the new coin/token (see separate heartbeat manual).
o
peRaTion
eagle ccTalk protocol
2
35