Pairing The Pedaling Monitor Sensor - Pioneer SGY-PM900H90 Installation Manual

Pairing the Pedaling Monitor Sensor

EN
This section describes how to pair the pedaling monitor sensor to the Cyclocomputer SGX-CA900.
It is necessary to pair the sensors on both the left and right sides. The right-side pedaling monitor sensor is used as an example
in this description. The procedure to pair the left side is the same as for the right side.
1
Check that the right transmitter and the left transmitter are in "Pedaling mode".
•
See page 8 to switch the modes.
2
Rotate the bicycle's crank set one rotation, and start the transmitter.
•
You have only 5 minutes to pair to the Cyclocomputer. If the transmitter stops while you are pairing, turn the crank set one revolution to
start the transmitter and continue the pairing.
3
Tap the SGX-CA900
4
Tap [Connect New].
32
(MENU) button and then tap [Sensors].