OLD TOWN A850HID
WITH 990 FITTER
WARNING:
TO AVOID FIRE, SHOCK OR DEATH, TURN OFF AND LOCKOUT POWER BEFORE PERFORMING ANY MAINTENANCE.
CAUTION:
THIS FIXTURE MUST BE WIRED IN ACCORDANCE WITH THE NATIONAL ELECTRIC CODE AND ALL APPLICABLE LOCAL
CODES. PROPER GROUNDING IS REQUIRED. ALL WORK SHOULD BE DONE BY A QUALIFIED ELECTRICIAN.
STEP 1
Unpack the base and lens assemblies for the fixture. Handle with
care. Recycle the empty packaging.
STEP 3
Close the fitter and
install the assembly on the
pole.
Make sure the "street side"
label is oriented to the street
or target area.
Fixture should be leveled
before tightening the set
screws.
Note: if the "street side"
label is missing, always
orientate fixture by facing
the casted mark on the cap
towards the street side or
target area.
CUSTOMER INSTALLATION INSTRUCTIONS
Shown with Optional
Twist-Lock
STEP 2
Connect the source circuit (pole wiring) to the terminal block that is
located in the fitter. Refer to wiring schematic. Be sure to verify ballast
wiring is correct for actual voltage.
"Street Side"
Label
Cast Mark
A850/990 12/13 STERNBERG LIGHTING. ALL RIGHTS RESERVED. PRINTED IN THE USA.
Set Screws
800-621-3376
555 Lawrence Ave., Roselle, IL 60172
info@sternberglighting.com
www.sternberglighting.com
Need help?
Do you have a question about the OLD TOWN A850HID WITH 990 FITTER and is the answer not in the manual?
Questions and answers