Keysight Technologies M9037A User Manual page 15

M9037A Functional Description
DisplayPort Video Connector
The DisplayPort (also known as DisplayPort++) video connectors connect the
M9037A to standard video monitors. Multiple monitors are supported. The
DisplayPort video ports provide a maximum resolution of 3840 x 2160 @ 60 Hz.
Resolution for other video interfaces (such as VGA) depends on the adapter
used. Typical maximum resolutions are:
For detailed information about the DisplayPort video, refer to
on page 32.
Ethernet
The M9037A has two RJ-45 connectors with link speed/activity LEDs on the
faceplate.
GPIB Connector
The GPIB connector on M9037A is a D-sub 25-pin connector and is used to
control external bench-top instruments. You need an optional GPIB adapter
cable to connect instruments. The on-board GPIB controller has the following
features:
- Compatible with the IEEE 488 standard
- On-board 2 KB FIFO for read/write operations
- Connect up to 14 instruments
- GPIB is a standard VISA Resource
Keysight M9037A PXIe Embedded Controller User Guide
DVI: 1920 x 1200 @ 60 Hz
HDMI: 2560 x 1600 @ 60 Hz
VGA: 1920 x 1200 @ 60 Hz
A GPIB cable is NOT supplied with the controller. Note that the
GPIB cable is a standard micro type 2 GPIB cable with standard
pin wiring and is not compatible with the M9036A Embedded
Controller GPIB cable. It is available from Keysight as an
accessory cable, part number Y1260A.
You must have Keysight IO Libraries Suite version 16.3 Update 2
(or later) to use the GPIB.
Introduction
"DisplayPort Video"
15