Setup - Badland Winches 61876 Owner's Manual & Safety Instructions

Specifications
Power Supply
Rated Capacity
Maximum Boat Weight
Line pull Line Speed
lb. kg. fpm
0 0 4.5
500 227 3.6
1000 454 2.9
1500 680 2.3
2000 907 1.7
Installation and Setup
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the
following pages, refer to Parts List and Diagram on page 14.
Temporary Winch Mounting
1. Use the Adapter Plate (31) to temporarily attach
the Winch to a 2" hitch ball on a vehicle.
2. The Adapter Plate has three pre-mounted Plate
Stud Bolt (38) / Nut (30) / Lock Washer (29) sets.
Push the Bolt heads into the keyhole slots on
the bottom of the Frame Assembly (34) and slide
them into the narrow section of the keyholes.
3. Bolt Adapter Plate to Winch Frame Assembly using
holes provided to lock components together.
permanent Winch Mounting
1. Select a mounting site on the boat trailer, vehicle
bumper, truck bed, or other suitable location.
NOTE: This Winch is not waterproof and is not intended
for use underwater. Do not mount in locations that are
subject to submersion in water.
Winch can generate extreme forces. Select a location
that can withstand the rated capacity without damage
or weakening. Steel reinforcement plates may be
needed or a certified welder may need to weld on
additional bracing depending on the mounting location.
2. If a mounting plate (not included) is used, it must
be flat and rated to at least the Winch's capacity.
Page 6
12VDC Battery
(not included)
Dead Pull: 2000 lb.
Marine Pull: 5000 lb.
Rolling Stock Pull: 6000 lb.
5,000 lb. – (about 18 ft. Boat
Length)
Amp Draw
mpm
1.4 3.1
1.1 6
2.3 11
0.9 17
0.5 21
For technical questions, please call 1-888-866-5797.
Drum (Dia. x L)
Overall Dimensions
Wire Rope
Hook Opening
Rated Line pull
Layer
lb.
1 2000
2 1520
3 1226
4 1027
5 884
4. Place teardrop-shaped hole in
Adapter Plate over hitch ball.
WARNING! At the start of winching when
using temporary winch mounting, take up
slack slowly and make sure Winch is securely
and properly mounted to hitch ball.
WARNING! Remove Winch after use. Do not
drive vehicle with Winch temporarily mounted.
3. Align the Winch perpendicular to the center
line of the vehicle at the desired location. Use
mounting holes in the Winch Frame Assembly (34)
as a template to mark the spots where holes will
need to be drilled in the installation surface.
4. Before drilling, verify that the installation
surface has no hidden components or
structural pieces that will be damaged.
5. Drill 3/8" holes at the marked locations.
6. Bolt the Winch to the installation surface using
3/8" galvanized/zinc plated bolts, nuts and washers
(not included) of SAE Grade 5 or higher.
1" x 3-1/8"
9-1/2" L x 7-1/2" W x 10" H
Ø3/16" x 30'
Galvanized Steel
11/16"
Cable Capacity
kg. feet meters
907 4.7 1.4
689 10.8 3.3
556 18.4 5.6
466 27.5 8.4
401 38.0 11.6
Item 61876