Tip
When the unit is reset, all the settings remain
unchanged.
Replace fuse
If there is no power, the fuse may be damaged
and need to be replaced.
1
Take out the unit from dashboard.
2
Check the electric connection.
3
Buy a fuse that matches the voltage of the
damaged fuse (15A)
4
Replace the fuse.
If the fuse breaks immediately after it has been
replaced, there may be an internal malfunction.
In this case, consult your Philips dealer.
12 Product
RESET
General
Power supply
Fuse
Suitable speaker
impedance
Maximum power
output
Continuous power
output
Pre-Amp output
voltage
Subwoofer output
voltage
Aux-in level
Dimensions
(W x H x D)
Weight (main unit)
Operating
temperature range
Disc player
System
Frequency response
Signal/noise ratio
Total harmonic
distortion
Channel separation
information
Note
Product information is subject to change without prior
notice.
12 V DC (11 V - 16 V),
negative ground
15 A
4 - 8
50 W x 4 channels
24 W x 4 channels (4
2.0 V ( CD play mode;
1 kHz, 0 dB, 10 k
load)
2.0 V (CD play mode,
61 Hz, 0 dB, 10 k
load)
178 x 101 x 160 mm
2.5 kg
-20°C to 70 °C
DVD / CD audio /
MP3 system
20 Hz - 20k Hz
>75dB
Less than 1%
>55dB
10% T.H.D.)
500 mV
EN
31