Advertisement
Table of Contents
- 1 Table of Contents
- 2 Introduction
- 3 Safety
- 4 Component Location
- 5 Installing the Exhaust Hose
- 6 Installing Cord Storage Hooks
- 7 Water Drain Accessories
- 8 Remote Controller
- 9 Control Panel
- 10 Remote Control
- 11 Operation
- 12 Maintenance
- 13 Troubleshooting
- 14 Power Supply
- 15 Specifications
- 16 Warranty
- Download this manual
Advertisement
Table of Contents
Related Manuals for Seeley Convair CP9CW3
Summary of Contents for Seeley Convair CP9CW3
- Page 1 OWNER’S MANUAL Portable Refrigerated Air Conditioner CP9CW3...
-
Page 2: Table Of Contents
CONTENTS Introduction ........1 Safety ...........2-3 Component location......4 Installing the exhaust hose ....5 Installing cord storage hooks ...6 Water drain accessories ....6-7 Control panel ........8 Remote control ........9 Operation........10-12 Maintenance ........13 Troubleshooting ......14 Specifications ........15 Warranty ........16-17 Please read these instructions prior to using the appliance and save them for future reference. -
Page 3: Introduction
1300 526 410 WARRANTY Convair air conditioners are warranted against faulty manufacture for 2 years after purchase. Refer to the warranty terms near the back of the manual. SEELEY INTERNATIONAL – OWNER’S MANUAL... -
Page 4: Safety
SAFETY During operation, water will collect in the This appliance is not intended for use by bottom tank of the air conditioner. Be persons (including children) with reduced careful when moving the unit to prevent physical, sensory or mental capabilities, or water from spilling. - Page 5 The appliance shall be stored in a room without continuously operating ignition sources (for example: open flames, an operating gas appliance or an operating electric heater). SEELEY INTERNATIONAL – OWNER’S MANUAL...
-
Page 6: Component Location
COMPONENT LOCATION Control Panel Vane Lever Air Outlet - vertical Remote Vane Lever Control - horizontal Drain pipe & plug Plug Castor Pipe Clip Handle Air Inlet Pipe Clamp Air Filter Exhaust Air Drain Outlet Adaptor Power Cord Cord Hooks Air Inlet Screws Drain... -
Page 7: Installing The Exhaust Hose
Fit the hose end to the window attachment, completely removed from the space and lock into place as before (Fig 5C). being cooled. 30cm Unit Window CATCH clasp “TOP” IS UPWARDS the side with "TOP" is upwards groove GROOVE SEELEY INTERNATIONAL – OWNER’S MANUAL... -
Page 8: Installing Cord Storage Hooks
INSTALLING ACCESSORIES CORD STORAGE HOOKS Assemble the cord storage hook onto the back of the unit with the 2 screws provided (Fig 7) . Ensure the hooks are pointing in the correct direction as shown. drainage port Cord hook direction pipe clip screw Cord hook... - Page 9 When using the continuous drain option, ensure the unit is on a level surface. Ensure the drain hose is directed downwards, is not raised above the outlet, is not kinked and is clear of obstructions (Fig 10). SEELEY INTERNATIONAL – OWNER’S MANUAL...
-
Page 10: Control Panel
CONTROL PANEL + / - button Display Cool Mode indicator Dry Mode indicator Wifi Fan Speed Fan Mode indicator indicator Fan button Mode button Wifi button Timer button On/Off button NOTE! To avoid damage to the control panel, do not operate with sharp objects. REMOTE CONTROLLER Signal transmitter Set fan speed... -
Page 11: Remote Control
“beep” when a signal has been received. If there is no beep, press the remote button again, ensuring it is within range (6 metres) of the air conditioner. NOTE: WASTE BATTERIES SHOULD BE DISPOSED OF CORRECTLY SEELEY INTERNATIONAL – OWNER’S MANUAL... -
Page 12: Operation
OPERATION Step 6: Press the FAN SPEED button STARTING THE AIR CONDITIONER on the control panel or remote control to adjust the fan speed. Each press will cycle Step 1: Ensure the cooler is plugged in and the fan speed between low, medium, high switched on. - Page 13 Holding these buttons will produce rapid adjustment. When complete, press the TIMER ON button again to set - “ON” will stop blinking ¹ icon will be displayed. Pressing the TIMER ON button again will CANCEL the TIMER ON function. SEELEY INTERNATIONAL – OWNER’S MANUAL...
- Page 14 OPERATION cont. WiFi INSTALLATION CONTROL FLOW CHART OPERATING SYSTEMS Requirements for User’s smart phone: iOS system Support iOS7.0 and above version Android system Support Android 4.0 and above version DOWNLOAD AND INSTALLATION Scan the QR code or search ‘Ewpe smart” from the application market to download and install it.
-
Page 15: Maintenance
Operate the unit in fan only mode for a few hours, to thoroughly dry the inside. • • Clean or change the filter. • Unplug and carefully store the power cord and plug end. • Replace in the original carton or cover for storage. SEELEY INTERNATIONAL – OWNER’S MANUAL... -
Page 16: Troubleshooting
TROUBLESHOOTING Problem Check The air conditioner does Is the air conditioner plugged in? not run. Is there a power failure? Is the “E8" WATER FULL error code flashing? Drain the tank as shown (Fig 17). Is the room temperature below the set temperature? Is there direct sunshine? Remember to close curtains The air conditioner has or blinds. -
Page 17: Specifications
MAIN BOARD DISP1 DISP1 HIGH-WP HIGH-WP DISPLAY CAP. BOARD WIFI MODULE YEGN WATER LEVEL SWITCH MOTOR CAP. As a policy of continual product improvement, this manual, its contents and specifications are subject to change without notice. SEELEY INTERNATIONAL – OWNER’S MANUAL... -
Page 18: Warranty
WARRANTY In this warranty: or us means Seeley International Pty Ltd ABN 23 054 687 035, and our contact details are set out at the end of this warranty; means you, the original end-user purchaser of the Goods; Supplier means the authorised distributor or retailer of the Goods that sold you the Goods in Australia; and... - Page 19 PRIVACY NOTICE Seeley International Pty Ltd ABN 23 054 687 035 will use the personal information you provide us with to provide warranty support for the product you have purchased and to inform you about other products and services. If you choose not to supply us with the information requested, we may be unable to provide you with warranty support.
- Page 20 It is the policy of Seeley International to introduce continual product improvement. Accordingly, specifications are subject to change without notice. Please consult with your dealer to confirm the specifications of the model selected. Warranty Service Australia 1-300-526-410 seeleyinternational.com convair.net.au 00268201-A...
Need help?
Do you have a question about the Convair CP9CW3 and is the answer not in the manual?
Questions and answers
I cannot move the directional vanes they are stuck at a weird angle.
The manual does not provide specific instructions for fixing stuck directional vanes on the Seeley Convair CP9CW3. However, you can try the following general troubleshooting steps:
1. Ensure the air conditioner is turned off and unplugged for safety.
2. Gently check if the vane levers (vertical and horizontal) are obstructed or misaligned.
3. Try to move the vanes manually with light pressure to free any minor blockages.
4. If the vanes are still stuck, inspect for dirt or debris that may be causing the issue and clean if necessary.
5. If the problem persists, contact your dealer or a designated service agent for assistance.
Do not attempt to dismantle the unit yourself, as this may void the warranty.
This answer is automatically generated