Run Phantom Test To Verify Setup - Geomagic Sensable Phantom Omni Device Manual

I P
NSTALLING THE HANTOM

Run Phantom Test to Verify Setup

Run Phantom Test to Verify Setup
2-4 Omni Device Guide
O D
MNI EVICE
5 For Windows® XP Users- After you have connected the Phantom Omni device to
your computer, the Microsoft "Found New Hardware Wizard" dialog will appear.
(This may take a few moments).
Continue as appropriate for your operating system:
6 Select Install the software automatically (recommended) and click Next.
7 When the Completing the Found New Hardware Wizard window opens, click
Finish to complete the install process.
In this section you will run the Phantom Test application to confirm that the device is
properly connected and installed.
1 Select Start>All Programs>Sensable>Phantom Test.
2 If the device is properly connected and installed, the Phantom Test application will
open and you will be in select mode. Gently move the Phantom arm and the Phantom
test application will synchronously display the movement in the display window.
If the device is not properly connected, you will receive the following:
"The Phantom device named 'Default Phantom'
could not initialize properly."
If you encounter this error message first check to see that the Omni is the selected
device in the Phantom Configuration tool. If you still encounter problems,
reconnect the device and try again.