Table of Contents
Advertisement
Task
Configure an IPv4 or IPv6
management route to the
network from which you
are accessing the system.
Configure a Username and Password
Configure a system username and password.
Task
Configure a username
and password to
access the system
remotely.
Configure the Enable Password
EXEC Privilege mode is accessed by the enable command. Configure a
password as a basic security measure. When using a console connection, EXEC
Privilege mode is unrestricted by default; it cannot be reached by a VTY
connection if you have not configured a password. There are two types of enable
passwords:
•
enable password stores the password in the running/startup configuration
using a DES encryption method.
•
enable secret is stored in the running/startup configuration by using a
stronger, MD5 encryption method.
Dell Networking recommends using the enable secret password.
Task
Create a password to
access EXEC
Privilege mode.
24
Installing the Software
Command Syntax
management route {ipv4-address
| ipv6-address}/mask gateway
Command Syntax
username username password
[encryption-type] password
Command Syntax
enable [password | secret] [level level]
[encryption-type] password
Command Mode
CONFIGURATION
Command Mode
CONFIGURATION
Command Mode
CONFIGURATION
Advertisement
Table of Contents
