Advertisement
4. conTenTs
M8 Fixings (13mm) c/w nuts & Washers
Telescopic Upright
M5 Phillips Machine
Screws c/w nuts &
Washers
latch Shoulder Screw c/w
locknut and Washer.
M6 Phillips Machine Screws c/w nuts & Washers
description
"A" Frame Sub Assembly
Bottom Cross Bar
Intermediate Cross Bar
Top Cross Bar Fabrication
Telescopic Uprights
M8 Fixings c/w nuts & Washers
M6 Phillips Machine Screws c/w nuts & Washers
latch Shoulder Screw c/w M5 nuts & Washers
M5 Phillips Machine Screws c/w nuts & Washers
Check contents from list. In the unlikely event of a missing component please contact your Sealey stockist.
5. asseMbly
5.1.
Tools reQuired:
5.1.1.
13mm spanner, 10mm spanner, 8mm spanner and Phillips screwdrivers for M6 & M5.
5.2.
asseMbly
5.2.1.
Fit intermediate cross bar to pre-assembled "A" frames (nB! diagonally opposed latch positions). do noT fully tighten fixings.
5.2.2.
Fit bottom cross bars to "A" frames. do noT fully tighten fixings.
5.2.3.
From diagrams, firstly latch (Fig 1) and then "over centre" lock (Fig 2) "A" frame both sides. Tighten all screws.
Sub assemble telescopic uprights to top cross bar (M8 fixings). Fit with interference "Pips" outermost and do noT fully tighten
5.2.4.
fixings.
5.2.5.
lower sub assembled telescopic uprights into "A" frames and intermediate cross bar guides. This will require a small force as the
interference "Pips" pass through the guides.
5.2.6.
Insert "dog legged" pin through any of the holes in the telescopic uprights. Rotate pin to the "safe" retained position. Tighten top
cross bar fixings. With "A" frames latched and locked both sides, height set, the trestle is ready for use.
© Jack Sealey limited
Top Cross Bar
Intermediate Cross Bar
Interference
"Pip"
Qty
2
2
1
1
2
8-sets
8-sets
2-sets
2-sets
Original Language Version
Pre-assembled "A" Frame legs, Upright
Supports, "dog leg" Pin & Chain
Swivel Stop (deployed)
Telescopic Upright
Bottom Cross Bar
"dog leg" Pin & Chain
(shown in retained position)
FdT3.V2 Issue 3 (HF) 10/12/18
Advertisement
