Advertisement
INSTALLATION INSTRUCTIONS
RX1 and RX2 LEDGINE
3-Pin Receptacle:
Receptacle screws
5-Pin Receptacle:
Receptacle screws
©2016 Philips Lighting Holding B.V. All rights reserved.
Philips reserves the right to make changes in specifications
and/or to discontinue any product at any time without notice
or obligation and will not be liable for any consequences
resulting from the use of this publication.
philips.com/luminaires
32001872 rev. D 01/16
Page 2 of 2
Screw driver slot
5) Positioning Photo Control Receptacle
A) For 3-Pin Photo Control Receptacle
Loosen both receptacle screws and rotate the center of the
receptacle using a flat screwdriver to the desired
orientation. Tighten screws to lock position.
B) For 5-Pin or 7-Pin Photo Control Receptacle
Fully remove both receptacle screws and rotate the
receptacle 180 degrees. Re-install screws, being sure to
fully tighten until gasket is compressed. DO NOT ROTATE
90 DEGREEES. Holes keyed at 90 degrees have a different
spacing and may cause screws to bind or break.
CAUTION! DO NOT REMOVE LENS FRAME. ACCESS DOOR
WILL FALL, AND IP AND UL RATINGS OF LUMINAIRE WILL BE
COMPROMISED.
If service or replacement needs to be performed on lens or lens
frame, contact factory. LED boards must be handled in an ESD
Protected Area (EPA).
Philips Lighting North America Corporation
200 Franklin Square Drive, Somerset, NJ 08873, USA
Tel. 855-486-2216
Philips Lighting Canada Ltd.
281 Hillmount Rd, Markham, ON, Canada L6C 2S3
Tel. 800-668-9008
Advertisement
