KI Pirouette Assembly Instructions

Assembly Instructions
Pirouette
®
Table-to-Table Ganging
September 2014
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Side-to-Side Ganging, 24/30"
Pirouette Nesting & Fixed-Base
Tables
Tables
Note: Take note of correct ganging
hook and peg mounting locations
to assure proper latching for each
type of installation. The instructions
on this page detail ganging of
24 & 30" wide tables side-to-side.
For 18" wide tables, see
instructions on pages 3 & 4.
1. As illustrated, and based on the
table width, position the two
ganging hooks as shown, at the
underside of the first table. Install
the two hooks to the first table
using two pegs and #14 x 1
wood screws. Next, install two pegs
at the other illustrated locations for
future use to store ganging hooks
(Figure 1).
2. At the second table, install two pegs
in line with the first set of pegs
(Figure 1).
3. Move tables together and swing the
ganging hooks of the first table to
securely engage the pegs under the
second table (Figure 2).
4. When tables have been un-ganged,
simply swing the two ganging
hooks around and snap them onto
the two pegs installed for storage
(Detail A).
/ "
1
2