Advertisement
3.1
Cable Connection Reference
1. Route a cable into the cabinet.
2. Pull the cable to the copper bar to which the cable will be connected, determine the cable length,
and label the cable.
•
Mark a line where the cable is to be cut.
•
Mark a line where the cable is to be stripped and an OT/DT terminal is to be crimped.
3. Pull the cable that has been marked out of the cabinet, cut the cable from the marked position,
and strip the cable and crimp an OT/DT terminal at the other marked position.
4. Connect the cable with a crimped OT/DT terminal to the corresponding copper bar and bind it to
a nearby beam.
5. Clean foreign matter inside the cabinet.
4
Advertisement
