Final Hardware Installation (Chain) - Softlog Systems ICP2-GANG Quick Start

ICP2-GANG Quick Start
3.3.1 Connect programmer to the PC
3.3.2 Run "ICP_Win" software
3.3.3 Press "No" if message "Newer firmware is available. Upgrade now?" appears
3.3.4 Repeat COM port selection (see 3.2.3) if communication error occurs.
NOTE: if programmer address is not 1 then communication error will occur during
connection
3.3.5 Open "Programmer/Assign Address to GANG Box"
3.3.6 Press button "BoxAddress = XX" to assign a new address to the connected
programmer
3.3.7 Place sticker with box address (number) on the programmer
3.3.8 Connect the next programmer to be learned to the PC
3.3.9 Repeat steps 3.3.1 - 3.3.7
3.3.10 Press Alt-F4 to exit the software

3.4 Final Hardware Installation (Chain)

Skip this paragraph if you use only one programmer (up to 4 channels)
3.4.1 Connect programmer number 1 to the PC with USB or RS-232 cable
3.4.2 Connect RS-232 output of the 1-st programmer to RS-232 input of the 2-nd
programmer
IMPORTANT:
3.4.3 Connect RS-232 output of the 2-nd programmer to RS-232 input of the 3-nd
programmer and so on
Rev: Mar-2017
don't leave non-terminated output of RS-232 cable
Page 3 of 5