Page 1
KATANA-100/212 Mk II KATANA-HEAD Mk II KATANA-Artist Mk II This Owner’s Manual applies to the KATANA-50 Mk II. KATANA-100 Mk II, KATANA-100/212 Mk II, KATANA-HEAD Mk II, and KATANA-Artist Mk II. Explanations for specific models are distinguished by an icon...
Intellectual Property Right • Never use benzine, thinners, alcohol or solvents of any • Roland and BOSS are either registered trademarks or • Do not connect this unit to same electrical outlet that is kind, to avoid the possibility of discoloration and/or...
KATANA-50 Mk II, KATANA-100 Mk II, KATANA-100/212 Mk II, KATANA-HEAD Mk II Top Panel * The illustration shows the KATANA-HEAD Mk II. KATANA-50 Mk II does not have a PRESENCE knob, [CAB RESONANCE] switch, nor does it have TONE SETTING buttons CH3 and CH4.
Here you can store or recall sounds that you’ve set up on the panel. [GLOBAL EQ] button On the KATANA-50 Mk II you can store a total of four sounds. On the KATANA-100 Mk II, KATANA-100/212 Mk II, KATANA-HEAD Mk II, or Turns the global equalizer on/off.
Panel Descriptions Rear Panel KATANA-50 Mk II KATANA-100 Mk II, KATANA-100/212 Mk II, KATANA-HEAD Mk II 17 18 * The illustration shows the KATANA-HEAD Mk II. KATANA-100 Mk II and KATANA-100/212 Mk II do not have MIDI jack and SPEAKER OUT jacks.
Page 7
CH 1 and CH 2. If you connect an expression pedal (sold separately: leave the [STEREO EXPAND] switch or [EXPAND] switch turned “OFF. ” Roland EV-5, BOSS EV-30, BOSS FV-500L, BOSS FV-500H), you can * The POWER AMP IN jack and the INPUT jack cannot be used use your foot to vary the volume.
You can connect two units and use them for KATANA-Artist Mk II stereo output or as dual amps. Connecting a footswitch (sold separately: BOSS FS-6, FS-7, or FS-5L) Switch Explanation Use one KATANA-Artist Mk II unit by itself. Connect two KATANA-Artist Mk II units for stereo output.
Turning the Power On/Off If you connect an expression pedal (sold separately: Roland EV-5, BOSS EV-30, BOSS FV-500L, BOSS FV-500H), you can use the pedal to vary the volume or control an effect such as WAH. * Once everything is properly connected (p. 4–p. 7), be sure to follow the procedure below to turn on their power.
Using the dedicated software allows you to do the following: 5 Easily download dedicated effects from Boss Tone Central (http:// bosstonecentral.com) download site into the amp. 5 Edit the effect settings. 5 Back up effects and other internal settings, or restore settings from a backup.
Block Diagram KATANA-50 Mk II -Secondary (Windows) -Primary (Windows) -Input/Output 3,4 (Mac) -Input 1,2/Stereo Out(1,2) (Mac) * No signal from the USB will POWER CONTROL be output from the speaker. POWER INPUT FOOT PREAMP EFFECTS MASTER VOLUME SPEAKER EXP PEDAL...
Main Specifications BOSS KATANA-50 Mk II: Guitar Amplifier BOSS KATANA-100 Mk II: Guitar Amplifier BOSS KATANA-100/212 Mk II: Guitar Amplifier BOSS KATANA-HEAD Mk II: Guitar Amplifier BOSS KATANA-Artist Mk II : Guitar Amplifier KATANA-50 Mk II KATANA-100 Mk II KATANA-100/212 Mk II...
Page 13
GA-FC sticker Footswitch: BOSS FS-5L Footswitch: BOSS FS-5L, BOSS FS-6, BOSS FS-7 Options Expression pedal: Roland EV- Expression pedal: Roland EV-5, BOSS EV-30, BOSS FV-500L, BOSS FV-500H (sold separately) 5, BOSS EV-30, BOSS FV-500L, GA FOOT CONTROLLER (GA-FC) BOSS FV-500H * 0 dBu = 0.775 Vrms...
Need help?
Do you have a question about the KATANA-50 Mk II and is the answer not in the manual?
Questions and answers