• Follow the instructions below to make sure that you install and use the product safely. • You may only connect this product using other products from Rusta’s lighting system (Belys). To connect the light, you must use a Belys transformer or another Belys product that is connected to the Belys system’s transformer.
ASSEMBLY 1. When you insert these lights into decking, you need to use a drill bit with a diameter of Ø2.6 cm. 2. Put the lights into the drilled holes. 3. Connect the light to the Belys transformer or another Belys product that is connected to the Belys system’s transformer.
Page 4
Tack för att du valt att Läs igenom hela bruksanvisningen köpa en produkt från Rusta! innan montering och användning! Trädgårdsbelysning – Decklight 5 x 0,15 W Se till att produkten installeras, används och underhålls på rätt sätt enligt instruktionerna. Spara bruksanvisningen för senare bruk. SÄKERHETSFÖRESKRIFTER •...
MONTERING 1. För nedsänkning av belysningen i trall använd en borr med Ø 2,6 cm. 2. Sänk ned belysningen i de borrade hålen. 3. Anslut belysningen till Belys-transformator alternativt annan Belys-produkt vilken är ansluten till Belys-systemets transformator. Kontrollera att kontakten är korrekt monterad och att kabeln inte rör sig.
Page 6
Les gjennom hele bruksanvisningen produkt fra Rusta! før installasjon og bruk! Hagebelysning – Decklight 5 x 0,15 W Sørg for at produkten monteres, brukes og vedlikeholdes riktig i henhold til instruks- jonene. Ta vare på bruksanvisningen for fremtidig bruk. SIKKERHETSINSTRUKSJONER •...
MONTERING 1. For nedsenking av belysningen i terrassebord, bruk en drill med Ø 2,6 cm. 2. Senk ned belysningen i de borrede hullene. 3. Koble belysningen til Belys-transformator, alternativt et annet Belys-produkt som er koblet til Belys-systemets transformator. Kontroller at kontakten er korrekt montert, og at kabelen ikke rører seg.
Page 8
• Die folgenden Anweisungen helfen Ihnen, das Produkt richtig zu ins- tallieren und zu nutzen. • Dieses Produkt darf nur in Verbindung mit anderen Produkten des Rusta Beleuchtungssystems (Belys) eingesetzt werden. Der Anschluss der Beleuchtung an das Belys-System erfolgt über einen Belys-Trans- formator oder ein anderes, angeschlossenes Belys-Produkt.
MONTAGE 1. Beim Einbau der Leuchten in Holzfußböden benötigen Sie einen Bohrer mit Durchmesser 2,6 cm. 2. Stecken Sie die Leuchten in die Bohrlöcher. 3. Schließen Sie die Beleuchtung über einen Belys-Transformator oder ein anderes, angeschlossenes Belys-Produkt an das Belys-System an. Stellen Sie sicher, dass der Stecker richtig eingebaut ist und dass sich das Kabel nicht bewegt.
Need help?
Do you have a question about the DECKLIGHT and is the answer not in the manual?
Questions and answers