Advertisement
3
Upgrade procedures
To upgrade the µFLO to the µFLO
3.1
µFLOG5 board layout label installation
When upgrading to the µFLO
label. This label contains information regarding the µFLO
various pin-outs contained on the board. Use the following instructions to install the
new label.
1.
Locate the old tag on the inside of the enclosure door.
2.
Wipe the old tag with a clean soft cloth to remove any dust or debris that may
keep the new tag from adhering.
3.
Remove the coated back from the new display tag.
4.
Place the new tag on top of the old tag.
3.2
µFLOG5 product identification label installation
G5
The µFLO
upgrade kit comes with a product identification label. This label contains
the new model number of the flow computer for easy identification. Use the following
instructions to install the new label.
1.
Locate the product identification label. When facing the closed flow computer,
the label is on the upper right hand corner of the enclosure.
2.
Wipe the old tag with a clean soft cloth to remove any dust or debris that may
keep the new tag from adhering.
3.
Remove the coated back from the new label.
4.
Place the new tag on top of the old tag.
3.3
Disconnect power, cables, and field wiring
To disconnect all cables, wiring, and expansion boards from the IMV:
1.
Disconnect the external power / charger connector (Figure 1).
µFLO (G3) electronic board
BATTERY
J6
EXT PWR / CHA RG ER
(+)
1
(-)
2
Figure 1: µFLO
G5
G5
, the upgrade kit comes with a new board layout
+
–
J7
G5
electronic board power connections
use the following procedures:
BATTERY
EXT PWR / CHA RG ER
(+)
1
(-)
2
G5
motherboard and the
G4
µFLO
electronic board
J15
+
–
J17
2105515-001 rev. AB | 5
Advertisement
