Switching On / Off; Reset Feature; Setting The Clock - Neon MTB830 Instruction Manual

Switching ON / OFF

When you first connect the unit to the AC power, the unit will be in clock mode.
- Press the button to switch the unit on. The word "HELLO" will display on the display lens.
A countdown of 10 seconds starts for preheating of the system. Then, the system will switch
to the last selected source.
- Press the button to switch the unit back to clock mode. The words "GOOD BYE" will
display on the display lens.

Reset Feature

Long pressing the
BF
then press the
P-EQ
the display lens.
Note: This feature is only available for standby mode.

Setting the Clock

Caution: You can set the clock in clock mode only.
1. In clock mode, long pressing the
seconds to activate the clock setting mode, the time format [24--H] or [12--H] will blink.
2. Press the / buttons on the remote control to select a time format.
3. Press the
CLOCK
4. Repeat above steps 2-3 to set the hour and minute.
Note:
- To exit clock setting mode without storing, press the
- If no button is pressed in 10 seconds, the unit exits clock setting mode automatically.
- If a power failure occurs or the unit is disconnected from the mains, the clock setting will be
lost.
button for 3 seconds or more to display the software version of the unit,
button to resets all the settings to factory default, "RESET" will display on
CLOCK
button to store the setting, the hour digits blink.
button on the remote control for more than 2
button.
L
- 11 -