Advertisement
STACKING KIT INSTALLATION INSTRUCTIONS
STEP 6
Lift and position dryer
into the position on the
washer shown above, slide
dryer backwards to make
contact with rear brackets.
CAUTION : To prevent noise, check the followings.
•
Make sure the washer is level.
•
Make sure the dryer's leveling legs are tightened up.
(Stacking kit: SKK-7*, SKK-8*, for 27" models)
STEP 7
Align rear brackets with
mounting holes on the
rear of dryer as shown
above.
STEP 8
LOOSELY assemble rear
brackets to the back of
the dryer using two (2)
Screws- Phillips Pan Head
(6006-001174) for each
rear bracket as shown
above.
Extra screws may be
included with this kit.
STEP 9
Tighten screws on the
dryer side of the rear
bracket.
WARNING : Additional gas hook-up components are
required for gas dryer.
StakingKit_DC68-01052R-09_EN.indd 2
STEP 10
Tighten screws on the
washer side of the rear
bracket.
* DO NOT REVERSE THE ORDER OF
STOP
STEPS 9 & 10.
HERE
STEP 11
Stacked Unit is now ready
to be installed. Refer
to detailed installation
instructions packed with
products.
(WASHER & DRYER ONLY)
Stacking kit components
Stacking Support Guides (2)
Rear Bracket (2) (WF5*K**, WF4*H**,
WF4*K**, WF4*M**, WF4*N**, WF18H**,
WF20H**, WF20M**, WF22H**,
WF22K**, WF15K**, WF16J65**)
Rear Bracket (2) (WF5*R**, WF4*R**)
Stacking Support Guides (2)
Rear Bracket (2) (WF56H**)
Screws-Hex Head (4)
Screws Phillips-Pan Head (8)
Washer (4)
Rear Bracket
(WF5*K**, WF4*H**,
WF4*K**, WF4*M**,
WF4*N**, WF18H**,
WF20H**, WF20M**,
WF22H**, WF22K**,
WF15K**, WF16J65**)
Screw-Hex Head
SKK-BB (M5, L10)
SKK-7*, SKK-8* (M5, L16)
Stacking Support Guide
SKK-7*, SKK-8* - DC61-04159A
SKK-7*, SKK-8* - DC61-04160A
SKK-7*, SKK-8* - DC61-04955A
SKK-BB
- DC61-01480B
SKK-BB
- DC61-03846A
SKK-BB
- 6009-001476
SKK-7*, SKK-8* - 6002-001431
- 6006-001174
- DC60-00044A
Rear Bracket
Rear Bracket
(WF56H**)
(WF5*R**, WF4*R**)
Screw Phillips-Pan
Washer (ID5, OD10)
Head
(M4, L12)
2019-03-08
2:27:51
Advertisement
