Numark NDX800 Setting Up

Setting up the controller the dj|io with traktor le

Hide thumbs Also See for NDX800:

Setting Up the NDX800 Controller the DJ|iO with Traktor LE

This guide will walks through setting up one or two Numark NDX800 Controllers and a DJ|iO USB

audio interface with Traktor LE.

Contents

Install the Latest Software and DJ|iO Drivers ......................................................................... 1

NDX800 and DJ|iO Hardware Setup ...................................................................................... 2

Traktor LE Setup Wizard......................................................................................................... 2

Traktor LE Audio Setup........................................................................................................... 4

Traktor LE Controller Manager Setup..................................................................................... 5

Note: The NDX800 Controller is a class-compliant USB MIDI device. No extra drivers are

needed for your Mac or PC to recognize it.

1. Before you begin, make sure you have the latest available DJ|iO drivers for your system

installed on your computer. Visit www.numark.com/djio.

2. Next, make sure you have the latest version of Traktor LE installed.

If you do not have Traktor LE installed, download it here:

You'll need the authorization code supplied with your product to register the software.

Launch Traktor LE, then go to Help > Launch Service Center. Select the Updates tab and

make sure you download any Traktor updates you see.

www.numark.com/traktorle

Table of Contents

Need help?

Do you have a question about the NDX800 and is the answer not in the manual?

Page 1 Setting Up the NDX800 Controller the DJ|iO with Traktor LE This guide will walks through setting up one or two Numark NDX800 Controllers and a DJ|iO USB audio interface with Traktor LE. Contents Install the Latest Software and DJ|iO Drivers ................. 1 NDX800 and DJ|iO Hardware Setup ..................
Page 2 NDX800 and DJ|iO Hardware Setup 3. Connect the NDX800 Controller(s) and DJ|iO to USB Ports on your computer. Power on the NDX800 Controller(s). 4. On the NDX800 hardware itself: • Set both the left and right decks (if you’re using two units) to USB-MIDI source mode.
Page 3 Then click Next. 9. On the next page, set manufacturer to Numark. If you’re using two NDX800 Controllers, set model to NDX800 LE Dual Deck. If you’re using a single NDX800, set model to NDX800 LE Single Deck. Click Next.
Page 4 On Macintosh, go to Traktor > Preferences. 12. Click on Audio Setup. • Make sure that Numark USB Audio Device is selected. 13. To set up your audio input and output configuration click on Output Routing on the left-hand side of the preferences window.
Page 5 B on the screen in Tracktor LE If you’re using two NDX800 units, Next to Device Target, select Deck A. 16. If you’re using two controllers, setup your second NDX800 to control Deck B in Traktor LE: 1. Next to Device, select NDX800 DeckB Controls.