Operation - Linking The Remote; Troubleshooting - Casper ADJUSTABLE Owner's Manual

OPE RAT ION — LIN K IN G T H E REM OTE
A
CO N N EC TI N G O N E R E M OT E TO O N E B A S E
B
CO N N EC TI N G O N E R E M OT E TO T WO B A S E S
12
Double click the Link button as shown until the
LED light on the control box turns on. Release
the button and the LED light will turn on.
Simultaneously press and hold the
Head Up
and Foot Up buttons (the left button and
middle button located on the top row of the
remote) until the remote's backlight starts
flashing. When the LED light on the control
box turns o and the remote backlight stops
flashing, release the two buttons.
Test the bed to make sure it is working, and
repeat the steps if it is not.
Locate one of the control boxes. Double click
the Link button on the control box as shown.
The LED light will turn on.
Simultaneously press and hold the Head Up
and Foot Up buttons (the left button and the
middle button located on the top row of the
remote) until the remote's backlight starts
flashing. When the LED light on the control
box turns o and the remote backlight stops
flashing, the linking is complete.
Locate the second control box. Double click the
Link button on the control box as shown in the
Simultaneously press and hold the Head Down
and Foot Down buttons (the left button and
the middle button located on the bottom row
of the remote) until the remote's backlight starts
flashing. When the LED light on the control
box turns o and the remote backlight stops
flashing, the linking is complete.
Test the bed to make sure it is working, and
repeat the steps if it is not.
T ROU B LE SHO OT I N G
In the event the Casper Adjustable Base fails to operate, investigate the symptoms and
possible solutions provided below:
Remote control
illuminates and
electronic components.
appears to be
• Defective surge protection device or electrical outlet. Test
operable, but no
outlet by plugging in another working appliance.
features of the
• Electrical circuit breaker may be tripped. Check electrical
bed will activate.
service breaker box to verify.
• Re-link the remote control (see the Linking the Remote
section of this manual for programming procedures).
No features of the
bed will activate.
electronic components.
• Defective surge protection device or electrical outlet. Test
outlet by plugging in another working appliance.
• Electrical circuit breaker may be tripped. Check electrical
circuit breaker box to verify.
Remote control will • Replace batteries in the remote control.
not illuminate.
Head section will • Base mechanism may be obstructed. Elevate base and
elevate, but will not
check for obstruction. Remove obstruction.
return to the
• Headboard may be too close to the edge of the mattress.
horizontal (flat)
Verify that distance between headboard brackets and
position.
mattress is su cient. Adjust if required.
Head or Foot Lift
• Check batteries in remote, replace if necessary.
Function has minor
• Make sure that you are following the duty cycle of the motor
interference during
operation.
• Press the lift buttons squarely and accurately.
• Control box may be experiencing common Radio Frequency
Interference from other radio transmitting devices (see
Linking the Remote).
The remote is • Lift the battery cover on remote and remove the yellow
causing interference
sticker to expose the DIP switches. Slide the switches to
with appliances,
di erent positions.
TV, garage door
opener, another
• After re-linking, test the bed to make sure it is working,
bed in a di erent
and repeat steps if it is not.
room, etc.
13