Replacing The Printer Paper - DNP QW410 Installation & Running Manual

5. Connect your printer.
sure your printer is powered
OFF. Connect the power cord
to the printer (blue circle)
and plug it into a wall outlet.
Connect a USB cable to the
type-B USB port and to the
computer (yellow circle).
Power ON the printer and
computer.
6. If necessary, use the paper
spacers. If you're using 4 inch paper, install the spacers so
the paper aligns with the print head for proper printing. The
spacers lock into place so that they do not move during use.
If you're using 4.5 inch paper,

Replacing the Printer Paper

1. Empty the scrap bin.
paper tray from the front of the printer. Remove the scrap
bin and throw away any scraps. Set the scrap bin aside.
2. Remove the old paper (if necessary).
spools from the paper compartment. Remove the old paper
from the spools and throw it away.
3. Prep the new paper roll.
remove a roll of paper. Remove the plastic but do not
remove the edge seal at this time. Check that the paper
edges are flat and are not protruding from the center of the
roll. Place the new paper roll on the paper spools. Be sure
to press the spools against the paper roll to set the paper
tightly against the spools.
Make
do not use the
If you haven't already, remove the
Open the printer media box and
spacers.
Remove the paper
5