Do you have a question about the 706/5165 and is the answer not in the manual?
Questions and answers
Summary of Contents for CUGGL 706/5165
Page 1
CUGGL TRAVEL COT GREY 706/5165 IMPORTANT! KEEP THE INSTRUCTION FOR FURTHER REFERENCE Suitable from birth to 36 months, up to 15kgs Important-Please read the instruction fully before starting assembly If you need help or have further question, call the Customer Helpline 03456 400 800...
Page 2
Important-Please read the instruction before assembly and keep it for further reference BEFORE ASSEMBLING THIS COT, READ AND UNDERSTAND THE FOLLOWING INSTRUCTIONS All assembly fittings should always be tightened properly and that fittings should be checked regularly and retightened as necessary.
Page 3
Components If you need help or have further question, 03456 400 800 call the Customer Helpline Please check if you have all the parts listed below before starting assembly...
Page 4
Unzip the travel bag and remove the frame and mattress. Place the cot in a vertical position and open the touch fasteners to remove the mattress. With the cot in folded vertical position on the floor, pull the feet apart so that they are approximately 60cm or 24inches apart.
Page 5
Push the center of the cot base downwards until it audibly locks into place. Place the mattress in the travel cot with the padded side up, align the touch fasteners on the mattress with those on the base and press down to ensure they are stuck together.
Page 6
Folding the cot Loosen the fasteners on the back of mattress and take mattress out from the travel cot. Lift the handle in the middle of the base, and then pull the handle upwards. Notice: Ensure to hold the tube of either side at the bottom while lifting the handle up.
Page 7
Repeat this process on the short sides. Check that all 4 sides have disengaged properly and then pull the center of the base, if you have difficulty unlocking the sides, try to lift the center of the base a little higher and start the process again.
Page 8
If you need help or have further question, call the Customer Helpline 03456 400 800 This product complies with EN716-1&-2:2008+A1:2013...
Need help?
Do you have a question about the 706/5165 and is the answer not in the manual?
Questions and answers