Table of Contents
Advertisement
Quick Links
INSTRUCTION MANUAL
E47 Model
E25 Model
E76 Model
ES Series Surgical Scrub Sinks
Installation - Operation - Maintenance - Cleaning
OSHPD
C
Pre-Approved
Read and understand all of the instructions and safety information in
this manual before operating this product.
MAN-009 Rev D
© 2019 MAC Medical, Inc.
03/2019
Advertisement
Table of Contents
Related Manuals for Mac Medical ES Series
Summary of Contents for Mac Medical ES Series
- Page 1 INSTRUCTION MANUAL E47 Model E25 Model E76 Model ES Series Surgical Scrub Sinks Installation - Operation - Maintenance - Cleaning OSHPD Pre-Approved Read and understand all of the instructions and safety information in this manual before operating this product. MAN-009 Rev D ©...
-
Page 2: Table Of Contents
• ES25 - single basin • ES47 - double basin • ES76 - triple basin PURPOSE OF THIS MANUAL This user manual details the installation, operation maintenance and cleaning of the MAC Medical Economy Scrub Sinks. This manual also contains general specifications, warnings and cautions. Table of Contents Warnings and Cautions Icon Key... -
Page 3: Warnings And Cautions Icon Key
MAC Medical or by or by other manufacturers, unless such a combination has been specifically endorsed by MAC Medical. MAN-009... -
Page 4: General Specifications
Instruction Manual General Specifications 1. Material: a. Sink basin and sink top: 14 gauge, 300 series stainless steel b. Sink skirt: 18 gauge, 300 series stainless steel. 2. Plumbing Material a. 1/2” copper or brass pipe 3. Utility requirements: a. Cold water - 20 to 50 psig 70 deg F max b. -
Page 5: Economy Sink Uncrating Instructions
Instruction Manual Economy Sink Uncrating Instructions Inspection 1. Receiving area must meet all State and Local regulations prior to unpacking. 2. Customer must inspect skid and Sink both before and after unpacking to determine if any items were damaged during shipping. 3. - Page 6 Instruction Manual 8. On smaller model Economy Sinks, there is a Z-Bar attached with zip-ties to the bottom rear of the sink. Clip the zip-ties and remove the Z-bars (Fig. 4). Fig. 4: Z-Bar and zip-ties 2 Zip-ties Z-Bar 9. Remove the Sink Hardware boxes from their locations and lift the sink off of the wooden skid. The Ecomony Sink is now ready for installation.
-
Page 7: Installation
Instruction Manual Installation 1. Check water supply and waste terminal locations - A. Be sure all connections are safely accessible to the sink and in proper working condition. NOTE: For proper sink operation the hot water temperature must be 120 degree F. B. -
Page 8: Recommended Mounting Specifications And Water Supply Locations - Single Basin
Instruction Manual Recommended Mounting Specifications and Water Supply Locations - Single Basin 635mm 25" 406.40mm 16" BOTH Z BRACKETS 203.20mm BROKEN OUT SECTIONS 8" TO SHOW Z BRACKET (SUPPLIED WITH SINK) 7.14mm 9/32" HOLE IN BRACKET 330.20mm 13" 598.73mm 23.68mm 23 9/16"... -
Page 9: Recommended Mounting Specifications And Water Supply Locations - Double Basin
Instruction Manual Recommended Mounting Specifications and Water Supply Locations - Double Basin WALL SURFACE 1193.80mm 47" 149.23mm 5 7/8" 406.40mm 406.40mm 16" 16" 7.14mm 9/32" Hole in Bracket Broken Out Sections Show Z Brackets (Supplied with Sink) 228.17mm 330.20mm 8 63/64" 13"... -
Page 10: Recommended Mounting Specifications And Water Supply Locations - Triple Basin
Instruction Manual Recommended Mounting Specifications and Water Supply Locations - Triple Basin WALL SURFACE 1930.40mm 76" 685.80mm 685.80mm 27" 27" 171.45mm " Broken Out Sections [7.14mm] Show Z Brackets 8X Ø 9/32” (supplied with Sink) Hole in Brackets 330.20mm 13" 598.73mm 23 9 "... -
Page 11: Installing And Operating The Soap Spout
Instruction Manual Installing and Operating the Soap Spout To prevent damage during shipment, the soap dispenser is stored inside the sink basin. Soap Dispenser tubing is also included. The dispenser spout should be installed before hanging the sink. 1. To install - remove the bushing (Fig. 7 - Item 3 shown in green). 2. -
Page 12: Connect Drain Pipe To Drain And Plumbing To Water Lines
Instruction Manual Connect Drain Pipe to Drain and Plumbing to Water Lines Local building or plumbing codes may require modifications to the information provided. You are required to consult the local building and plumbing codes prior to installation. If the information provided here is not consistent with local building or plumbing codes, the local codes should be followed. This product must be installed by a licensed contractor in accordance with local codes and ordinances. -
Page 13: Adjusting Mixing Valve Temperature
Instruction Manual Adjusting Mixing Valve Temperature The supplied mixing valve is factory pre-set to 120ºF (49ºC). The valve temperature adjust range: 90°- 160° F (32°C to 71°C). Maximum hot water temperature: 200°F (93°C). Temperture setting (within the valve adjustment range) to be determined by local installation requirements. 8. -
Page 14: Replacement Parts For Manual Knee Operated And Infrared Self-Activated Sink Plumbing
Instruction Manual Replacement Parts for Manual Knee Operated and Infrared Self-Activated Sink Plumbing Both plumbing configurations shown below indicate which parts are replaceable. See table below for replacement part numbers. Fig. 15: Infrared self-activated sink plumbing Fig. 14: Manual knee operated sink plumbing Item # Description Item # Knee Operated Part # Item # Infrared Activated Part # Spout... -
Page 15: Infrared Controls (For Infrared Self-Activated Sinks Only)
Instruction Manual Infrared Controls (for Infrared Self-Activated Sinks only) Installation The sinks are supplied with a 24V power transformer(s) that connects to a standard duplex outlet (110/120V outlet required). Single basin sinks have one sensor, dual basin sinks have two sensors (one for each basin) and triple basin sinks have three sensors (one for each basin). -
Page 16: Optional Add-Ons
Instruction Manual Optional Add-ons An electronic sink timer kit (Fig. 17 - S0202-EST-KT) can be purchased and installed on economy sinks. The installation would require some alteration in the plumbing configuration. The installation instructions are covered in our MAN-028 which is available on our website (http://macmedical.com/) under Resources - Technical Publications - Manuals. Fig. -
Page 17: Instructions For Cleaning Stainless Steel Economy Sinks
Instruction Manual Instructions for Cleaning Stainless Steel Economy Sinks Stainless steel sinks must be cleaned on a regular basis to prevent any unnecessary damage to the stainless steel surfaces. When cleaning Ssainless steel sinks, make sure to use the proper approved cleaning agents and cleaning materials. -
Page 18: Limited Lifetime Warranty
EXPRESS OR IMPLIED, OF FITNESS AND / OR MERCHANTABILITY OR ANY OTHER WARRANTY IMPLIED BY CUSTOM, USAGE OR COURSE OF DEALING. Liability of MAC Medical under this warranty is limited to the repair and / or replacement of any products. MAC Medical specifically excludes and disclaims any responsibility for any incidental or consequential damages claimed to have arisen from any defect in workmanship or materials.
Need help?
Do you have a question about the ES Series and is the answer not in the manual?
Questions and answers