Removing And Installing 2.5" Drives From/In Tray - Siemens SIMATIC IPC1047 Operating Instructions Manual
Hide thumbs
Also See for SIMATIC IPC1047:
- Operating instructions manual (136 pages) ,
- Quick install manual (2 pages)
Table of Contents
Advertisement
6.2.3.4
Removing and installing 2.5" drives from/in tray
Requirement
● The tray has been removed, see section "Removing and installing a tray from/in the drive
cage (Page 65)".
● 1 drive
● 1 soft mounting base
Procedure
Removal
1. Place the tray with the drive (nameplate) on the bottom on the mounting base as shown
in the figure.
In the following figure, the installation in vertical format is shown on the left and the
installation in horizontal format on the right.
2. Unscrew the highlighted screws.
3. Lift up the tray and place it on the mounting base next to the drive.
SIMATIC IPC1047
Operating Instructions, 07/2019, A5E45118479-AB
Expanding and assigning parameters to the device
6.2 Drives
67
Advertisement
Table of Contents
