Advertisement
Available languages
Available languages
2-IN-1 Drip Filter/
Pressure Regulator with
1/2" Drip-Lock
Instructions
For outdoor use with cold water only.
Check local codes for installation requirements
If static water pressure exceeds 80 PSI, a pressure regulator should be
installed on the main sprinkler line.
Pressure test all water lines before covering pipe and timer control wire.
Warning: DO NOT use pipe dope on threads, use thread seal tape.
Step 1: Put 5 complete turns of tape
around the threads of each end of the
Filter Pressure Regulator
Adapter
®
Congratulations on your purchase of the Orbit
Filter Pressure Regulator. This revolutionary product
allows you to convert your 1" FPT irrigation valve into
a low pressure drip valve.
Features:
200 Mesh (removable) filter
30 Psi pressure regulator
I" MPT Inlet/outlet
Included 1"x1/2" FPT Drip-Lock
Important Guidelines
Installation Instructions
Step 2: Thread the Filter Pressure Regulator into
the valve until snug. Important: ensure that the
water flow arrow and pressure regulator point
away from the valve and towards the sprinkler pipe.
If desired, thread the adapter onto the pressure
regulated side of the 2-in-1 filter.
2-in-1
®
Adapter
®
pressure
regulator
Advertisement
Table of Contents
Related Manuals for Orbit 67798
Summary of Contents for Orbit 67798
- Page 1 2-IN-1 Drip Filter/ Pressure Regulator with 1/2" Drip-Lock Adapter ® Instructions Congratulations on your purchase of the Orbit 2-in-1 ® Filter Pressure Regulator. This revolutionary product allows you to convert your 1" FPT irrigation valve into a low pressure drip valve.
- Page 2 Removing fine debris from the filter. With your timer in the OFF position, remove the filter housing by unscrewing the housing ring. Gently remove the filter and flush with clean water. Ensuring that all four o-rings are in place. Replace housing and hand tighten the housing ring. Orbit Irrigation Products, Inc. ®...
- Page 3 DE 1/2" ® Felicitaciones por la compra del filtro regulador de presión del filtro 2 en 1 de Orbit . Este producto revolucionario le permite convertir su ® válvula de irrigación para rosca de tubo hembra (FPT) de 1" en una válvula de goteo de baja presión.
- Page 4 Retire suavemente el filtro y purgue con agua limpia. Compruebe que las cuatro juntas tóricas estén en su lugar. Cambie la carcasa y apriete a mano el aro de la carcasa. Orbit Irrigation Products, Inc. ®...
Need help?
Do you have a question about the 67798 and is the answer not in the manual?
Questions and answers