Add Content; Add Command; Move Playlist Command - Sony LMT-300 User Manual

The Enter Gap Duration popup appears, adjust the
Duration value, tap Accept and then tap Save
Seconds
Minutes
Hours
Accept
Note: You MUST tap Save before you leave this screen or
all changes will be lost.

Add Content

To add Content to the current Playlist, tap Content to
display available Composition Playlists (CPL). Tap either
the Scroll Up or Scroll Down
locate the Content of interest, tap the Content Title to
select, and then tap Add. The added Content appears as a
Playlist Element at the end of the Playlist.
Title
Add
Sub-Playlist
Content
Commands
The Time value shown in the left-most column is the time
when the Content will be presented based on its offset from
the start point (00:00:00) of the Playlist.
To move the newly added Playlist Element,
tap the Title to select and then tap Down or
Up (illustrated to the right) to move the selected Playlist
Element one event position in the desired direction.
Continue to tap Down or Up until the selected Playlist
Element is in the desired position in the Playlist.
When all changes are complete, tap Save. Edit Playlist
closes and you are returned to the MANAGE SHOWS pane.
1.When Commands are included in the Playlist you may
have to Save the Playlist and then reopen it to obtain a
view that represents the actual sequence of Playlist Ele-
ment presentation.
Close
Minus
Plus
Cancel
arrow until you
New Playlist Element
Added Here
Cancel
Save
1
Note: You MUST tap Save before you leave this screen or
all changes will be lost.

Add Command

To add Command(s) to the current Playlist, tap Command
to display the available Automation Controls. Tap either
the Scroll Up or Scroll Down
locate the Command of interest, tap the Command to
select, and then tap Add. The added Command appears as
a Playlist Element at the end of the Playlist.
When all changes are complete, tap Save. Edit Playlist
closes and you are returned to the MANAGE SHOWS pane.
Note: You MUST tap Save before you leave this screen or
all changes will be lost.
Note: The Ghostbuster function can only be enabled or
disabled during Lamp ON status.

Move Playlist Command

Playlist Commands can be moved within the SPL. To
move a Command in the SPL, tap either the Scroll Up
or Scroll Down arrow until you locate the target
Command, tap the Command event to select (the Edit
button appears) and then tap Edit.
Edit Playlist Tap Command
The Enter Offset popup appears, adjust the Offset value,
tap Accept and then tap Save. Edit Playlist closes and you
are returned to the MANAGE SHOWS pane.
Seconds
Minutes
Hours
Accept
Note: You MUST tap Save before you leave this screen or
all changes will be lost.
arrow until you
Edit
Save
Close
Minus
Plus
Cancel
Shows
16