NETGEAR ReadyDATA 5200 Software Manual page 144

- Update. Select how often the information in the graphic is updated. You can select
from 5 to 50 seconds.
• Network.
The Network throughput table shows the network usage for Tx and Rx traffic in bytes per
second. The range is flexible and depends on your selections from the drop-down lists
above the graphic. For example, the range can be 0 to 60 bytes or from 0 to 40 KB. The
upper part of the graphic indicates the Rx traffic; the lower part of the graphic indicates
the Tx traffic.
From the drop-down lists above the graphic, you can adjust the following settings:
- Network. Select all network interfaces, individual interfaces, individual VNICs, or
individual aggregation links.
- Protocol. Select all protocols or individual protocols (SMB, NFS, AFP, HTTP, SSH,
iSCSI, or SNMP).
- Period. Select the period over which the network usage is measured. You can select
from five minutes to one year.
- Update. Select how often the information in the table is updated. You can select from
5 to 50 seconds.
• Utilization.
The Volume utilization graphic shows the percentage that an individual volume or all
volumes are used. The range is from 0 to 100 percent.
ReadyDATA OS 1.2
System Maintenance and Monitoring
144