Marshall Electronics VS-PTC-150 Quick Setup Tech-Note

With cv620 (camera)

Hide thumbs Also See for VS-PTC-150:

Table of Contents

Download this manual

Quick Setup Tech-note using VS-PTC-150 (Controller) with CV620 (Camera)

1. Unpack CV620 (Camera) and VS-PTC-150 (Controller) and plug in power sources.

2. Use RS-232 Cable packed in VS-PTC-150 (Controller) box and plug in VGA-style comm cable with thumb

screws to (Controller) and plug round 8-pin connector to CV620 (Camera).

3. Confirm (Controller) is set to CAM: 001 on LCD Screen, or 002, 003, 004 matching ADDRESS of Camera.

Also confirm both Controller and Camera are set to VISCA or PROTOCOL V.

4. Or use RS-422 wire harness on VS-PTC-150 (Controller) and CV620 (Camera) and plug 2 wires into each

end using one wire to connect from Controller (position #1 – Ta) to Camera (position #6 RXD IN -), then

connect other wire to connect from Controller (position #2 – Tb) to Camera (position #7 RXD IN +).

VS-PTC-150 Controller

CV620 Camera

5. Confirm (Camera) is set to ADDRESS SELECTOR (Camera-ID) #1 position on back panel, or #2 ~ #7.

Table of Contents

Need help?

Do you have a question about the VS-PTC-150 and is the answer not in the manual?

Page 1 Also confirm both Controller and Camera are set to VISCA or PROTOCOL V. 4. Or use RS-422 wire harness on VS-PTC-150 (Controller) and CV620 (Camera) and plug 2 wires into each end using one wire to connect from Controller (position #1 – Ta) to Camera (position #6 RXD IN -), then connect other wire to connect from Controller (position #2 –...
Page 2 Push PRESET button, then Number (1~127) Preset, and Enter to Save (and Esc) vi.) to Recall location - Push SHOT then number key of saved location, and Enter E. Other Functions & Operation of Controller can be found in VS-PTC-150 (Controller) Manual or CV620 (Camera) can be found in CV620 Manual.