Change Ip; Relay Settings (For Door Opener); Relay Release Time - Multitek DIP70 Installation And User Manual

5.3.2 CHANGE IP

TO DEFINE THE BLOCK NUMBER AND DOOR NUMBER OF THE DOOR PANEL
If CHANGE IP icon is tapped at the SYSTEMS (SETTING) page CHANGE DEVICE IP appears.
As a default the door panel is defined as the first block and the first door (01-01). If the door panel is connected to a
different block and the door IP address of the device should be changed by entering the block number and the door
number.
The new screen asks entering "ENTER BLOCK NUMBER" and "ENTER DOOR NUMBER". After entering two digits for
each field SAVE icon is touched.
Note: The block number is entered between 01-99 and the door number is entered between 01-19.
After entering THE NEW BLOCK AND DOOR NUMBER the device becomes re-booth automatically.

5.3.3 RELAY SETTINGS (FOR DOOR OPENER)

If RELAY SETTING is tapped at the SYSTEM (SETTING) page RELAY SETTING page appears. This page allows to adjust
the relay operating(release) time and relay contact type.
5.3.3.a RELAY RELEASE TIME: This icon is used to set the relay operating (release) time. The default "RELAY
OPERATING TIME" is 1 seconds.
26