Advertisement
STEP 2-B: Install bracket using bolt through hole in the desk
This option is for desks with a grommet hole.
1. Attach the base (4) to the tube (3) by tightening screws with 2.5 × 2.5mm allen key.
2. Insert the bolt (12) into the hole of the bottom support 2 (13) to the base by tightening screws (C)
with 4 × 4mm allen key (E).
2. Turn the mount upside-down and put anti-slip rubber 1 (5) onto the bottom support 2 (13).
3. Insert the bottom support into the desk hole.
4. Attach anti-slip rubber 3 (14) onto the washer (15).
5. Screw in the washer with the butterfly knob (16).
3
1
4
2.5x2.5
Keep the tube opening direction
aligned with the base screw.
4
DESK
Size of the hole:
0.33" - 2.76" (8.5 - 70 mm)
03
For table thickness: 0.98" - 3.94" (25 - 100mm)
2
3
13
C
E
12
keep the counter-bore
side down.
5
6
DESK
14
15
16
STEP 3: Install monitor arms and fixed wreath
1. Insert fixed wreath (10) into the tube (3) making sure to keep it's narrow side downward.
2. Insert monitor arm 2 (2) into the tube (3).
3. Insert locating ring (11) into the tube (3);then insert fixed wreath (10) into the tube (3) and making
sure to keep it's narrow side downward.
4. Insert monitor arm 1 (1) into the tube (3).
5. Attach the tube cover (F) onto the tube by tightening M4x12mm screw.
6. Make sure the screws are tightly locked before hanging up the screens.
1
10
E
NOTE:
5
3
10
11
2
2
NOTE:
4
5
Tighten the handle
b
1
b
a
NOTE:
Tighten the handle
F
04
Advertisement
