Micro Height Adjust Assembly; Lubrication - Textron Jacobsen LF-1880 Service & Repair Instructions

OPTIONS
MICRO HEIGHT
ASSEMBLY
The micro height adjust can be disassembled for
repairs as shown in Figure 13C-17.

LUBRICATION

Use a hand grease gun when lubricating the Turf
Groomer components (Figure 13C-18).
Pump the gun slowly and carefully until a slight amount
of pressure is felt, then stop — DO NOT over grease.
ADJUST
Figure 13C-17. Micro Height Adjustment
Figure 13C-18. Lubrication
13C-18
As the time of assembly make sure the roll pin in the
pin assembly is on the BOTTOM when installing the
pin assembly in the pivot block.
Lubricate the groomer shaft bearings, roller shaft bear-
ings, and clutch monthly.
Lubricate the micro adjusters monthly. Wipe off excess
grease.