Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Clam Quick-Set Escape Series
Summary of Contents for Clam Quick-Set Escape Series
- Page 2 It is expressly understood that Clam Corporation’s liability for its products, whether due to breach of warranty, negligence, strict liability, or otherwise, is limited to the repair of the product as stated above. Clam Corporation is not liable for any injury, loss, damage, or expense, whether direct or consequential, including but not limited to loss of use, income, profit, or damage to material arising in connection with the sale, installation, use of, inability to use, or the repair or replacement of Clam Corporation products.
- Page 3 SAFETY INSTRUCTIONS Please fully understand and follow all safety WARNING instructions outlined in this booklet. Failure to do so could result in severe injury. • Do not use open flame heaters in your Injury or death may result from fire if tent fabric is screen tent.
- Page 4 Clam logo facing up. If it does not fall open naturally, unfold the tent until you can see the roof panel lying flat.
- Page 5 Step 7 (optional): Insert the vertical rods on either side of the screen tent’s door. Remove the Velcro retaining loop securing the pole to the adjacent wall. Once freed, install one end of the rod into the other’s end to make it one long rod.
- Page 6 TAKE DOWN INSTRUCTIONS Step 1: Remove all the stakes from the interior and exterior of the tent. Step 2: If used, remove the vertical door support rods from pockets at the bottom of the panel, pull apart, and refasten them with the Velcro straps located diagonally on the panels next to each side of the door.
- Page 7 SAFETY INFORMATION Please fully understand and follow all safety instructions as outlined. Failure to do so could result in severe injury or death. Do NOT use open flame heaters in your screen tent. Injury or death may result from fire if tent fabric is exposed to open flame.
- Page 8 For additional questions, comments or concerns please contact Clam Customer service at 763-231-4120 or email CustomerService@ClamCorp.com. Due to Clam’s continued product development, Clam reserves the right to change specifications without notice. For complete details, see the assembly and/or operating instructions that are provided and packaged with the purchased...
Need help?
Do you have a question about the Quick-Set Escape Series and is the answer not in the manual?
Questions and answers