Download Print this page

Troubleshooting - Sharp IB-HX9KA Operation Manual

Plasmacluster hair spa hair dryer

Advertisement

IB-HX9KA

TROUBLESHOOTING

Please ask the following questions before commissioning repairs or making consultations
Cold wind
No warm wind
The temperature varies
from time to time
The sound volume varies
from time to time
The airflow varies from
time to time
The warm wind becomes
cold from time to time
I am worried about the
smell of the wind coming
from the air outlet
About the Plasmacluster
ions
I do not feel the effects of
the Plasmacluster ions
The LED (blue) at the air
outlet of the body is off
The light flickers
IB-HX9KA.indd
18
Problem
Did you switch to the COLD, SCALP or WARM mode?
⇒ Switch to the HOT mode.
Did you attach the scalp massager?
⇒ If you attached the scalp massager, you cannot turn
Did you switch to BEAUTY mode?
⇒ In BEAUTY mode, the sound volume varies because
Is the air outlet or air inlet obstructed by dust?
⇒ Please remove the dust or other things obstructing the
If the above situation is excluded, please stop using the
appliance immediately and consult the customer service center.
During the generation of the Plasmacluster ions, ozone are
generated, which gives off a kind of smell from the air
outlet. The ozone is of the same concentration as natural
ozone, so it will not affect health.
The Plasmacluster ions are generated all the time when
the unit operates.
It can be repeatedly used if you clean it around once every
two months. So it is unnecessary to replace the unit.
Effects may vary depending on hair texture.
Effects may not be evident if: your hair was permed
recently; your hair was dyed; you have a wavy hair style;
your hair is very curly; your hair is thin, short or soft.
Does the electrode part of the unit have collected dust?
⇒ Please clean it.
Is the air outlet or air inlet obstructed by dust?
⇒ Please remove the dust or other things obstructing the
The LED (blue) is on only when the scalp massager is
attached. It is not an abnormality.
The light in the room where you use the fan may flicker due
to the use of the fan. This situation is caused by the control
of the warm wind, and is not an abnormality.
If you mind this, please change outlets.
Description
on modes other than SCALP and COLD.
of repeated switching between WARM and COLD
modes. This is not an abnormality.
ports.
ports.
E-18
Reference
E-9
Blu
fro
E-14
I w
I w
E-12
thin
E-16
Pu
Tu
tw
-
-
-
E-16
If the
imm
E-16
If an
imm
E-8
-
2017/06/20
8:50:12

Advertisement

loading