Super B EPSILON 12V90Ah Manual page 28

The Li-ion battery
cannot be
charged.
The capacity of
the Li-ion battery
has decreased.
Bluetooth errors
/ connection
problems
Touch display
errors
28
Li-ion battery is in operation mode.
Green LED is lit or flashing.(Chapter
3.5.10)
Li-ion battery is in alarm mode because
the charging voltage is too high.
Red LED is lit or flashing. (Chapter
3.5.10)
Li-ion battery is in alarm mode because
of high temperature.
Red LED is lit or flashing. (Chapter
3.5.10)
Li-ion battery is in alarm mode because
of too high charge current.
Red LED is lit or flashing (Chapter
3.5.10)
The cells within the Li-ion battery are
not properly balanced or the Li-ion
battery is worn out.
Connection rejected
Cannot put the Li-ion battery in storage
mode
Update takes very long
App can't find the Li-ion battery
Touch display show CAN error
Touch display doesn't show all
batteries in bank but does not show an
error
Check the installation of the Li-ion
battery.
Verify that the charging voltage is
within the Li-ion battery specifications.
(Chapter 3.2) Discharge the Li-ion
battery or press the S1 push button for
1 second.
Disconnect the Li-ion battery from load/
charger and wait for it to cool down.
Discharge the Li-ion battery or press
the S1 push button
Perform one full charge (100% SoC)
cycle to balance the cells.
Remove Bluetooth pairing from device
settings. Verify no other device is using
the Bluetooth connection.
Make sure the device is bonded by
double pressing the S1 push button
Solved when using software >2.5.0
Make sure the Li-ion battery is not in
sleep / storage mode. Li-ion batteries
using older software (<2.5.0) are
susceptible for having connection
issues. Try resetting the Li-ion battery
by using the sleep button attached to
connector J2.
Ensure the dip switch is set correctly
(1 down, 2 up, 3 down). Make sure the
CAN bus is terminated by the orange
terminator.
Go to the settings menu and press
'Start scan'.