NanoVibronix PainShield Quick Manual

PAINSHIELD QUICK GUIDE
Please read the complete PainShield manual before using the device and
pay attention to important warnings.
For maximal effectiveness ensure that the
active element is in full contact with clean,
hairless and oil-free skin
For extended patch usage follow handling
instructions on the patch label
1
Before applying the patch,
the skin should be thoroughly
cleaned. Remove the protective
liner from the treatment patch,
and keep it for storing after use.
4
Press the
ON/OFF
The device requires a few seconds to initialize and then displays the information screen.
When the device is in working or charging modes, it enters the screen saving mode.
To check the status press shortly on the
The device can be turned off at any time by pressing and holding the
For online guidance, please see:
https://youtu.be/h5NHm6apQbs
2
Attach the treatment patch to
the skin with the adhesive side
down over the area where the
pain is most intense.
button on the device for about
ON/OFF
Driver
seconds until beeping sound is heard.
2
button.
ON/OFF
www.nanovibronix.com
Active
Contact
element
snaps
Large
patch
3
Connect the patch to the device
cable using the contact snaps.
button for seconds.
2
Small
patch