Canon imagePASS-B2 Installation Procedure page 7

Installation Procedure > Installing the PS Unit
16) Install the Left Reader Cover. (2 Screws, 2 Rubber Caps)
Installing the PS Unit
1) Remove the 9 Face-Cover Seals on the Rear (The removed Face Seals will not be used.)
2) Install the 2 Support Plates.
• 4 Stepped Screws (M4)
• 4 Screws with Toothed Washers (Binding; M4x8)
Stepped Screw
Screws with
Toothed Washer
x8
Stepped Screw
Screws with
Toothed Washer
Installation Procedure > Installing the PS Unit
F-1-18
F-1-19
3) Remove the 4 Screws.
4) Install the Mounting Plate with the removed screws.
CAUTION:
Be sure to install it in the correction direction.
x4
5) Install the PS Unit in the direction of the arrow.
• 4 Screws with Toothed Washers (Binding: M4x8)
x4
7
Slot Hole
x4
Slot Hole
F-1-20
F-1-21
7