Setting The Dental Chair's "Rinse" And "Home" Positions; Programming The Chair Positions 1, 2, 3 And 4 - Castellini SKEMA 6 Series Operating Instructions Manual

SKEMA 6 / SKEMA 8
5.1.2. Setting the dental chair's "rinse" and "home" positions
This setting is specific for each operator.
Perform the following operations from the main screen:
• Bring the dental chair into the desired position with the manual movements
buttons.
NOTE: if the bowl is motor-driven, you can also store the bowl
position.
• Activate storage mode by pressing the
Storage mode activation is signalled by a short beep and by the dedicated
icon ( A ) on the TOUCH DISPLAY.
NOTE: Hold down button
saving the changes made.
• Press buttons "Automatic return" or "Rinse position" to assign the position
to the button.
The icon ( B ) referring to the program selected will appear on the TOUCH
DISPLAY to confirm that it has been stored.
NOTE: The "Rinse position" button brings the backrest and seat
into the rinse position.
When button "Rinse position" is pressed again, the backrest and seat return
to the previous position.

5.1.3. Programming the chair positions 1, 2, 3 and 4

This setting is specific for each operator.
Perform the following operations from the main screen:
• Bring the dental chair into the desired position with the manual movements
buttons.
• Activate storage mode by pressing the
NOTE: Storage mode activation is signalled by a short beep and
by the dedicated icon ( A ) on the TOUCH DISPLAY.
• Push the 1, 2, 3 or 4 keys to associate the relevant position to the key
(e.g. 3).
NOTE: The icon ( B ) referring to the program selected (e.g. 3) will
appear on the TOUCH DISPLAY to confirm that it has been stored.
NOTE: To call up a set position simply briefly press the button
assigned to the relative position.
button for at least 2 seconds.
for at least 2 seconds to quit without
button for at least 2 seconds.
- OPERATING INSTRUCTION
>2 sec
>2 sec
A
B
A
B
EN 31 31