Greentek GT-WP-50XTGYYZZ Installation Instructions Manual

LED Wall Pack
Parts Model:
LED Wall Pack : GT-WP-50XTGYYZZ
GT-WP-80XTGYYZZ
GT-WP-120XTGYYZZ
Specifications
Model Input Voltage
GT-WP-50XTGYYZZ 100-277VA
GT-WP-80XTGYYZZ 100-277VA
GT-WP-120XTGYYZZ 100-277VA
Cautions
CAUTION: This product use an input 100-277VAC driver of wide range
voltage, but the actual working voltage is dependant on the input
voltage of the photocell that is installed on the product. Normally the
input voltage of photocell is 120V/208V/240V/277V single range.
Please pay attention when installing.
WARNING: To avoid the risk of fire, explosion, or electric shock, this
product should be installed, inspected, and maintained by a qualified
electrician only, in accordance with all applicable electrical codes.
WARNING: To avoid electric shock:
•
Be certain electrical power is OFF before and during
installation and maintenance.
Installation
Figure 1: Remove two screws to access the inside
of the wall pack.
Power Factor Watt Input Current
0.92 50W 0.52A
0.92 80W 0.85A
0.92 120W 1.2A
INSTALLATION INSTRUCTION MANUAL
LED WALLPACKS LIGHT, 100-277VAC
Important: Read all instructions prior to installation
Features
GT-WP-50XTGYYZZ
GT-WP-80XTGYYZZ
• This LED wall pack light uses the latest in solid state lighting
technology for long life, low maintenance, and high efficiency.
• Can be used with a standard photocell on the enclosure, to make
it completely suitable for street lighting. (3000, 3002)
• An internal power-factor-corrected switch-mode supply allows it
to be used from any nominal 100V-277V, 60Hz AC supply
without any variation in light output.
• Suitable for use in the following locations:
• Ambient Temp: -20~+40°C
• Wet Locations
.
GT-WP-50XTGYYZZ
GT-WP-80XTGYYZZ
Figure 2: Dimension diagram
Note: Holes "A" and "B" will need
drilling before mounting
GT-WP-120XTGYYZZ
GT-WP-120XTGYYZZ