Table of Contents
Advertisement
The following steps must be performed to properly install your DVD-RAM.
Set drive's jumpers
Connect audio cable
Attach IDE BUS cable
Connect power cable
Mount DVD-RAM
Install CyberLink PowerDVD
Install VOB InstantWritesoftware (used for recording CDs)
SETTING JUMPERS
The mode select jumpers are six (6) straight angle pins located on the rear of the
DVD-RAM. By placing a jumper on the pins, you can select the following func-
tions:
CS: – Drive is configured using host interface signal CSEL
SL: – Configures drive as Slave
MA: – Configures drive as Master (default mode)
In most installations, jumper should remain in MA (Master) position (factory
default). It is recommended that you install your DVD-RAM only on the second-
ary IDE BUS. If you are installing on primary IDE BUS, your hard drive would
then be the Master, and you should set your DVD-RAM to the Slave position (SL).
PLACING DVD-RAM INSIDE YOUR COMPUTER
Now that you have set your drive's jumpers, you are ready to install your
DVD-RAM inside your computer.
IMPORTANT: Disconnect power from your computer system before be-
ginning installation.
2
™
software (used for viewing DVD movies)
Mode Select Jumpers
C
S
S
L
M
A
Advertisement
Table of Contents
