Table of Contents
Advertisement
Chapter 1 - English
Congratulations on purchasing an HP External USB Floppy Disk Drive. This document contains
information on setting up your floppy disk drive and installing the software necessary for its use.
Supported Platforms
To find out with which HP PCs support the HP External USB Floppy Disk Drive, go to the
following HP accessories web site:
www.hp.com/go/pcaccessories
Setting Up Your USB Floppy Disk Drive
NOTE
The following procedure is not required for HP Notebook computers.
Print out the readme.txt file on the HP External USB Floppy Disk Drive Software CD-ROM
before setting up your floppy disk drive.
1
2
Checking the
1
2
Hardware Installation
3
Installing the USB Floppy Disk Drivers
Windows 95 &
1
Windows 98
2
(Second Edition)
3
users
4
5
6
1.
Switch off your PC.
Connect the cable of the floppy disk drive to the USB port on your PC.
Restart the PC, press F2 when the F2 Setup prompt appears.
Select the Advanced menu, the floppy disk drive should be included in the list and should be
Enabled.
Press F10 to save and exit the program.
Insert the HP External USB Floppy Disk Drive Software CD-ROM if you haven't already
done so.
After starting, your PC will automatically identify the new hardware TEAC FD-05PUB.
The New Hardware Wizard dialog box will appear on screen, click on Next.
Click on Next to search for the best driver for your device.
Select Specify a Location, click on Browse and select the CD-ROM drive (typically this would be
your D: drive), type:
1
\win95\driver (for Windows 95)
D:\Driver\xxxx
1
\win98\driver (for Windows 98)
D:\Driver\xxxx
Select the driver file and click Next.
Once your PC has located the drivers, click on Next to complete the installation. Click Finish
when prompted.
where xxxx is your HP e-pc model
Advertisement
Table of Contents
