Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Phil&Teds Discovery 2015+
Summary of Contents for Phil&Teds Discovery 2015+
- Page 1 discovery 2015 + ™ Group I+II+III (9-36kg) 9-36 Kg Y 043846 ECE R44/04 SUITABLE FOR BS01N-B/S The product has been approved according to the strictest BS01N-BE/SE European. safety standards (ECE R 44/04) and is suitable BS01N-BC/SC for Group I+II+III(9-36KG). BS01N-BCE/SCE...
-
Page 2: Table Of Contents
Contents Contents 4.0 Care Instructions 4.1 Cleaning Introduction 4.2Checklist Safety warnings 5 - 7 Know your car seat 8 - 9 1.0 Use in the vehicle 1.1 Use in the vehicle 1.2 Legal requirements 1.3 Important notes 2.0 Securing your baby 11 - 13 2.1 Securing the harness 2.2 Tightening and loosening the harness... -
Page 4: Introduction
Introduction Introduction ™ The discovery complies with requirements applicable in market of sale Dear parents Thank you very much for purchasing our product. The function and design of this seat delivers the For rights & remedies, refer www.philandteds.com/warranty highest levels of safety and comfort when your child is in this child restraint. -
Page 6: Safety Warnings
Safety Warnings Safety Warnings • It is recommended that this car seat should be changed when it has been subjected to violent stresses in an accident or has become badly • WARNING: PLEASE READ THOROUGHLY worn, periodically inspect the harness for wear, BEFORE COMMENCING INSTALLATION AS paying particular attention to the attachment points, AN INCORRECT INSTALLATION COULD BE... - Page 7 Safety Warnings • WARNING: THIS CHILD SEAT MUST ONLY BE INSTALLED IN A FORWARD FACING POSITION. THIS SEAT IS CLASSIFIED AS: • Group I for children weighing from 9kg to 18kg (9months - 4 years approx.) • Group II for children weighing from 15kg to 25kg (4-6 years approx.) •...
-
Page 8: Know Your Car Seat
Know your car seat Diagonal belt guide for group 2 use 2. Head support 3. Shoulder pads 4. Buckle release button 5. Crotch strap 6. harness adjuster 7. harness release button 8. cushion 9. diagonal belt guide for group 1 use... - Page 9 Know your car seat 10. Locking device for head support 11. Metal yoke 12. Diagonal belt clip (for use in group 3 only, store at the bottom of the booster)
-
Page 10: Use In The Vehicle
Use in the vehicle 1.1 Use in the vehicle 1.2 Legal requirements This child seat is approved to ECE R44.04 and is ONLY suitable for use with a 3 point and diagonal seat belt, approved to UN/ECE Regulation No.16 or other equiva- lent safety standards. -
Page 11: Securing Your Baby
Securing your baby 2.1 Securing the harness • Place the right hand harness connector behind the left hand one, they should slot together neatly (2-A). • Push the harness ends into the hole in the buckle at the top of the crotch strap (2-B). •... -
Page 12: Adjusting The Shoulder Height
Securing your baby 2.3 Adjusting the shoulder height • The harness has 3 height positions. The straps should go into the slots nearest to the top of your child's shoulders. If your child's shoulders are between two pairs of slots, always use the higher position. •... -
Page 13: Adjusting The Headrest Height
Securing your baby 2.4 Adjusting the headrest height • The adjustable head support is designed to provide side impact protection for your child (when the seat is used with the backrest). • To adjust the height, unscrew the red locking device located at the top back of shell. -
Page 14: Installation In The Vehicle
Installation in the vehicle 3.1 Installation in vehicle for children up to 13kg • Place the child's car seat on a passenger seat with a 3 point seat belt. Make sure the child seat is facing towards the front of the car. •... -
Page 15: Installation In Vehicle For Children Up To 15 - 25Kg
Installation in the vehicle 3.2 Installation in vehicle for children up to 15 - 25kg • Your child will be secured using the vehicle's seat belt. It will therefore be necessary to remove the harness fitted to the child seat before use (3-G). Please see Adjusting the shoulder height 2-G/2-H. -
Page 16: Installation In Vehicle For Children Up To 22 - 36Kg
Installation in the vehicle 3.3 Installation in vehicle for children up to 22 - 36kg • The back section of the seat is removed by pushing the back of the seat away from the base of the seat (3-M/3-N). • Attach the diagonal belt clip, by threading the loose strap through the slot at the side of the seat base (3-O/3-P). -
Page 17: Care Instructions
Care instructions 4.1 Cleaning • REMEMBER: mis-using your child seat will reduce the protection and safety you offer your child. • If you are unsure about the fit of your child seat • The harness and plastic parts can be sponged please contact the local distributors or contact the with a mild detergent and warm water. - Page 18 Notice 1. This is a Universal child restraint. It is approved to Regulation No.44,04 series of amendments, for general use in vehicles and it will fit most, but not all, car seats. 2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the vehicle is capable of accepting a Universal child restraint for this age group.
- Page 19 © Phil and Teds Most Excellent Buggy Company Ltd 2012. We (Phil and Teds Most Excellent Buggy Company Ltd) own the intellectual property rights in our brands, designs and inventions featured in this publication. These include, without limitation, the phil~teds, adapt~survive!, ~, INLINE trade marks and INLINE DOUBLE BUGGY shape. We actively pursue people who infringe our intellectual property.
- Page 20 AUS/NZL phil&teds 102-112 Daniell Street Newtown, Wellington 6021 New Zealand + 64 4 3800 833 USA/CAN phil&teds USA Inc 221 Jefferson Street Fort Collins, CO 80524 USA. 1 800 839 4985 phil&teds UK 71-73 Victoria St Windsor, Berkshire SL4 1EH, United Kingdom +44 (0) 20-30519264 USA/CAN phil&teds Spain...
Need help?
Do you have a question about the Discovery 2015+ and is the answer not in the manual?
Questions and answers