Hitachi DV 14DBL Handling Instructions Manual page 31

Cordless impact driver drill
Table of Contents

Advertisement

Before
charging
While
charging
The pilot
lamp lights
or blinks in
Charging
red.
complete
Charging
impossible
The pilot
Overheat
lamp lights
standby
in green.
(2)
Regarding the temperatures of the battery
The temperatures for batteries are as shown in the Table 2, and batteries that have
become hot should be cooled for a while before being recharged.
Table 2 Recharging ranges of batteries
Batteries
BSL1430, BSL1830
(3)
Regarding recharging time
Depending on the combination of the charger and batteries, the charging time will become
as shown in Table 3.
Table 3 Charging time (At 20°C)
Battery
BSL1430, BSL1830
NOTE
The recharging time may vary according to the ambient temperature and power source
voltage.
4.
Disconnect the charger's power cord from the receptacle.
5.
Hold the charger fi rmly and pull out the battery.
NOTE
After operation, pull out batteries from the charger fi rst, and then keep the batteries
properly.
Table 1
Indications of the pilot lamp
Lights for 0.5 seconds. Does not
light for 0.5 seconds. (off for
Blinks
0.5 seconds)
Lights continuously
Lights
Lights for 0.5 seconds. Does not
light for 0.5 seconds. (off for
Blinks
0.5 seconds)
Lights for 0.1 second. Does not
light for 0.1 seconds. (off for
Flickers
0.1 seconds)
Lights continuously
Lights
Temperatures at which the battery can be recharged
Charger
31
Malfunction in the battery
or the charger.
Battery overheated.
Unable to charge
(Charging will commence
when battery cools).
0°C – 50°C
UC18YRSL
Approx. 45 min.
English

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Dv 18dbl

Table of Contents